Re: [PATCH 0/3] Add UFS Host driver support for SpacemiT K3 SoC

Hi Yixun,

On Mon, Jul 13, 2026 at 7:38 AM Yixun Lan <[email protected]> wrote:
>
> Hi Anirudh,
>
> On 22:40 Sun 12 Jul     , Anirudh Srinivasan wrote:
> > Hi Yixun,
> >
> > On Thu, Jul 02, 2026 at 02:31:34AM +0000, Yixun Lan wrote:
> > > This series try to add UFS support for SpacemiT K3 SoC, the controller
> > > components consists of System Bus Interface Unit, UFS Host Controller
> > > Interface, UFS Transport Protocol Layer, UFS Host Registers, Device
> > > Management Entity (DME), Transport Layer, Network Layer, Data Link
> > > Layer, PHY Adapter Layer, and M-PHY Interface. A more detail functional
> > > block diagram can be found in SpacemiT website, chapter 9.7.3 [1]
> > >
> > > Please note, in order to test this driver, the UFS clock driver[2] here
> > > should be applied first as a prerequisite patch.
> > >
> > > One known issue is that the device will occasionally raise BKOPS interrupt
> > > when doing some high load test, log from dmesg shows
> > >
> > > [  806.710763] ufshcd-spacemit c0e00000.ufshc: ufshcd_bkops_exception_event_handler: device raised urgent BKOPS exception for bkops status 1
> > >
> > > Link: https://spacemit.com/community/document/info?nodepath=hardware/key_stone/k3/k3_docs/k3_usermanual/09_memory_storage.md&lang=en [1]
> > > Link: https://lore.kernel.org/all/[email protected]/ [2]
> > > Signed-off-by: Yixun Lan <[email protected]>
> >
> > I see this during probe on a k3-pico-itx. Does the UFS chip on board
> > have an RPMB block on it? Is this error of any concern.
> >
> It's probably true of having a RPMB block, but not used in K3 platform, so can ignore
>
> > [    5.957864] ufshcd-spacemit c0e00000.ufshc: ufshcd_scsi_add_wlus: BOOT WLUN not found
> > [    5.963319] bus_add_device: cannot add device 'ufs_rpmb0' to unregistered bus 'ufs_rpmb'
> > [    5.971155] ufshcd-spacemit c0e00000.ufshc: Failed to register UFS RPMB device 0
> >
> Maybe disable CONFIG_RPMB to silent this? I've not tested this option locally

I'm testing on a distro defconfig, so it has this option enabled.

Is there anything we can do in the driver to have it ignore the RPMB?
If the error is a red-herring, we shouldn't be displaying it at all in
the first place.

Regards
Anirudh Srinivasan

>
> --
> Yixun Lan (dlan)