[PATCH 2/2] riscv: dts: spacemit: k3-com260-ifx: add eeprom on i2c1

Enable i2c1 for k3-com260-ifx and use it for a 24c02 eeprom. This
eeprom, unlike the one connected to i2c2, is part of the carrier board.
Some boards do not have any data programmed on this eeprom from factory.

Signed-off-by: Jennifer Berringer <[email protected]>
---
 arch/riscv/boot/dts/spacemit/k3-com260-ifx.dts | 15 +++++++++++++++
 arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi   | 12 ++++++++++++
 2 files changed, 27 insertions(+)

diff --git a/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dts b/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dts
index e7f76cd24b903..a5c08a7a781a9 100644
--- a/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dts
+++ b/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dts
@@ -20,6 +20,21 @@ chosen {
 	};
 };
 
+&i2c1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&i2c1_1_cfg>;
+	status = "okay";
+
+	eeprom@50 {
+		compatible = "atmel,24c02";
+		pagesize = <8>;
+		reg = <0x50>;
+		read-only;
+		size = <256>;
+		status = "okay";
+	};
+};
+
 &sdhci0 {
 	pinctrl-names = "default","uhs";
 	pinctrl-0 = <&mmc1_cfg>;
diff --git a/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi b/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
index 5b9045e014345..6482d24be1394 100644
--- a/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
@@ -78,6 +78,18 @@ gmac1-phy-0-pins {
 		};
 	};
 
+	/omit-if-no-ref/
+	i2c1_1_cfg: i2c1-1-cfg {
+		i2c1-1-pins {
+			pinmux = <K3_PADCONF(54, 5)>,	/* i2c1 scl */
+				 <K3_PADCONF(55, 5)>;	/* i2c1 sda */
+
+			bias-pull-up = <1>;
+			drive-strength = <25>;
+			power-source = <1800>;
+		};
+	};
+
 	/omit-if-no-ref/
 	i2c2_1_cfg: i2c2-1-cfg {
 		i2c2-1-pins {
-- 
2.55.0