[PATCH 2/2] riscv: dts: spacemit: Make dtschema recognize the etherent PHY correctly on K3 com260 board

Since the previous commit does not change the phy node name,
the dtschema can not recognize the type of the ethernet phy,
so the following error is produced:

/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dtb: phy@1 (ethernet-phy-id001c.c916): $nodename:0: 'phy@1' does not match '^ethernet-phy(@[a-f0-9]+)?$'
        from schema $id: http://devicetree.org/schemas/net/realtek,rtl82xx.yaml
/arch/riscv/boot/dts/spacemit/k3-com260-ifx.dtb: phy@1 (ethernet-phy-id001c.c916): Unevaluated properties are not allowed ('reg', 'reset-assert-us', '
reset-deassert-us', 'reset-gpios' were unexpected)
        from schema $id: http://devicetree.org/schemas/net/realtek,rtl82xx.yaml

Change the nodename to make the dtschema can recognize the right
PHY type.

Fixes: 9db839d52ccd ("riscv: dts: spacemit: Fix phy id check for the phy on com260 board")
Signed-off-by: Inochi Amaoto <[email protected]>
---
 arch/riscv/boot/dts/spacemit/k3-com260.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
index 2a07cd8f2a56..c7a04a338d08 100644
--- a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
@@ -173,7 +173,7 @@ &eth1 {
 	status = "okay";
 
 	mdio {
-		phy1: phy@1 {
+		phy1: ethernet-phy@1 {
 			compatible = "ethernet-phy-id001c.c916";
 			reg = <1>;
 			reset-gpios = <&gpio 1 5 GPIO_ACTIVE_LOW>;
-- 
2.55.0