Re: Rust virtio drivers in Linux
"Michael S. Tsirkin" <[email protected]> Mon, 18 May 2026 04:44:45 -0400
| Newsgroups | dev.linux.lists.virtio-dev |
|---|---|
| Message-ID | <[email protected]> |
On Mon, May 18, 2026 at 11:12:06AM +0300, Manos Pitsidianakis wrote: > Hello all, > > I have a new device type proposal for the virtio spec I hope to > publish to virtio-comment soon and I have a reference C driver > implementation for Linux. However I would prefer to implement the > driver in Rust, and should it be accepted upstream, abandon the C > driver out-of-tree. > > In preparation for that, I wrote bindings for the virtio subsystem and > sent them to LKML. I had forgotten to CC virtio-dev. > > The RFC I sent 2 weeks ago has a sample virtio-rtc driver that doesn't > register itself to the rtc subsystem. Since then I wrote a virtio-rng > driver instead that is fully equivalent to the C driver. I haven't > sent it yet because my last revision did not receive any comments yet. > My WIP tree is https://github.com/epilys/linux/tree/rust-virtio Yea, sorry I didn't start reviewing yet. My problem is my rust knowledge is limited, and kernel rust - nonexistent. I did the crab book a while ago but didn't do much since except a small terminal emulator project. > I'd like to hear any feedback and suggestions, especially from the > kernel virtio and Rust maintainers. > > Note: An issue with virtio drivers is that they require bindings both > for virtio and the device subsystem. For example I had to write hwrng > bindings for the virtio-rng driver. Does this require more > co-operation from kernel maintainers in order to get things merged? Well the rust kernel doc at Documentation/rust/general-information.rst says you are supposed to also write "abstractions" as opposed to just "bindings" and they have to be "ergonomic". I will be frank I'm not the best judge about "egonomic". So yes, more kernel maintainers who understand this thing would help a lot. > Miguel: WDYT? > > Thanks in advance! > > ---------- Forwarded message --------- > From: Manos Pitsidianakis <[email protected]> > Date: Sun, May 10, 2026 at 4:38 PM > Subject: [PATCH RFC v3 0/6] Add Rust virtio bindings and sample device > To: Miguel Ojeda <[email protected]> > Cc: Manos Pitsidianakis <[email protected]>, Peter Hilber > <[email protected]>, Stefano Garzarella > <[email protected]>, Stefan Hajnoczi <[email protected]>, Viresh > Kumar <[email protected]>, Michael S. Tsirkin <[email protected]>, > Boqun Feng <[email protected]>, Gary Guo <[email protected]>, Björn Roy > Baron <[email protected]>, Benno Lossin <[email protected]>, > Andreas Hindborg <[email protected]>, Alice Ryhl > <[email protected]>, Trevor Gross <[email protected]>, Danilo > Krummrich <[email protected]>, Daniel Almeida > <[email protected]>, <[email protected]>, > Jason Wang <[email protected]>, Xuan Zhuo > <[email protected]>, Eugenio Pérez <[email protected]>, > <[email protected]>, <[email protected]>, > Manos Pitsidianakis <[email protected]> > > > Hi all, this RFC series adds Rust bindings for Virtio drivers > (frontends in virtio parlance). > > As a PoC, it also adds a sample virtio-rtc driver which performs > capability discovery through the virtqueue without registering any clock. > > Before I send a cleaned-up non-RFC I would like some initial feedback > (i.e. is it something the upstream wants?) > > This was tested with the rust-vmm vhost-device-rtc device backend that I > wrote[^0]: > > [^0]: https://github.com/rust-vmm/vhost-device/tree/main/vhost-device-rtc > > Instructions: > > Run the daemon in a separate terminal: > > $ cargo run --bin vhost-device-rtc -- -s /tmp/rtc.sock > > Then run the VM: > > $ qemu-system-aarch64 \ > -machine type=virt,virtualization=off,acpi=on \ > -cpu host \ > -smp 8 \ > -accel kvm \ > -drive if=virtio,format=qcow2,file=./debian-13-nocloud-arm64-daily.qcow2 \ > -device virtio-net-pci,netdev=unet \ > -device virtio-scsi-pci \ > -serial mon:stdio \ > -m 8192 \ > -object memory-backend-memfd,id=mem,size=8G,share=on \ > -numa node,memdev=mem \ > -display none \ > -vga none \ > -kernel /path/to/linux/build/arch/arm64/boot/Image \ > -device vhost-user-test-device,chardev=rtc,id=rtc,virtio-id=17,num_vqs=2,vq_size=1024 > \ > -chardev socket,path=/tmp/rtc.sock,id=rtc \ > ... > > Example output: > [ 1.105238] rust_virtio_rtc: Probe Rust virtio driver sample. > [ 1.105645] rust_virtio_rtc: Found 1 vqs. > [ 1.136050] rust_virtio_rtc: process_requestq got buf 16 bytes > [ 1.136125] rust_virtio_rtc: Got response! Ok(RespCfg { head: > ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > num_clocks: Le16(3), reserved: [0, 0, 0, 0, 0, 0] }) > [ 1.136701] rust_virtio_rtc: Got response! Ok(RespClockCap { > head: ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_type: 3, leap_second_smearing: 0, flags: 0, reserved: [0, 0, 0, > 0, 0] }) > [ 1.136724] rust_virtio_rtc virtio0: cannot expose clock 0 > (type 3, variant 0, flags 0) to userspace > [ 1.137259] rust_virtio_rtc: Got response! Ok(RespRead { head: > ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_reading: Le64(1777890485031060388) }) > [ 1.137277] rust_virtio_rtc: #0 clock reading = 1777890485031060388 > [ 1.137749] rust_virtio_rtc: Got response! Ok(RespClockCap { > head: ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_type: 1, leap_second_smearing: 0, flags: 0, reserved: [0, 0, 0, > 0, 0] }) > [ 1.137769] rust_virtio_rtc virtio0: cannot expose clock 1 > (type 1, variant 0, flags 0) to userspace > [ 1.138247] rust_virtio_rtc: Got response! Ok(RespRead { head: > ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_reading: Le64(1777890485032086075) }) > [ 1.138264] rust_virtio_rtc: #1 clock reading = 1777890485032086075 > [ 1.138730] rust_virtio_rtc: Got response! Ok(RespClockCap { > head: ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_type: 2, leap_second_smearing: 0, flags: 0, reserved: [0, 0, 0, > 0, 0] }) > [ 1.138751] rust_virtio_rtc virtio0: cannot expose clock 2 > (type 2, variant 0, flags 0) to userspace > [ 1.139253] rust_virtio_rtc: Got response! Ok(RespRead { head: > ReqHead { msg_type: Le16(0), reserved: [0, 0, 0, 0, 0, 0] }, > clock_reading: Le64(338567896865557) }) > [ 1.139270] rust_virtio_rtc: #2 clock reading = 338567896865557 > > Concerns - Notes - TODOs > ======================== > > - Virtqueue lifetimes don't neatly apply to Rust as expected, so a lot > of times we have to go through unsafe pointer dereferences (though > which are guaranteed by Virtio subsystem to be valid, for example when > a callback is called with the vq argument). There's a potential for > misuse and definitely could use better thinking. > - `struct virtio_device` is not reference-counted like other implemented > device types in rust/kernel. Maybe we need to change C API first to > make them reference counted, assuming this doesn't break anything? > - The sample driver obviously conflicts with the C implementation, so > this would either need to move out of samples/ or figure out some way > to handle this in kbuild. > - kernel::virtio module and its types need a few rustdoc examples that I > will add in followup series > - Note that the registration of RTC clocks etc in the sample driver is > not done, I'm putting it off until I receive some feedback first. The > sample driver otherwise does send and receive data from the virtqueue > as a PoC. > > PS: No LLMs used so any mistakes and goofs are solely written by me. > > Signed-off-by: Manos Pitsidianakis <[email protected]> > --- > Changes in v3: > - Removed unused methods from virtio API > - Clean up how scattergather lists are added to virtqueues by using > owned SGTables only, and make the API safe(r) > - Add RAII cleanup for find_vqs return value that calls del_vqs > - Reset device after remove callback > - Significantly clean up sample driver as a result of the other cleanups > - Link to v2: https://lore.kernel.org/r/[email protected] > > Changes in v2: > - Move helper ifdefs to helper file (thanks Alice) > - Changed CONFIG checks to IS_ENABLED to allow for CONFIG_VIRTIO=m > - Split all use imports to one item per line according to style guide > - Fixed wait_for_completion_interruptible*() rustdocs > - Use Jiffy type alias in wait_for_completion_interruptible_timeout() > - Pepper and salt #[inline]s wherever appropriate as per style guide > - Split probe() into probe() and init() to allow cleaning up if init > fails > - Remove unnecessary Send and Sync unsafe impls for > kernel::virtio::Device > - Remove unnecessary LeSize and BeSize > - Accept Option<_> for virtqueue callback when creating a VirtqueueInfo > - Made all vq buffer adding operations unsafe > - Use AtomicU16 instead of Cell<u16> for sample virtio driver > - Fix RespHead field types in sample virtio driver > - Fix response error checking in sample virtio driver > - Change some device contexts in method signatures > - Link to v1: https://lore.kernel.org/r/[email protected] > > --- > Manos Pitsidianakis (6): > rust/bindings: generate virtio bindings > rust/helpers: add virtio.c > rust/kernel/device: return parent at same context > rust: add virtio module > rust: impl interruptible waits for Completion > samples/rust: Add sample virtio-rtc driver [WIP] > > MAINTAINERS | 9 + > rust/bindings/bindings_helper.h | 5 + > rust/helpers/helpers.c | 1 + > rust/helpers/virtio.c | 37 ++++ > rust/kernel/device.rs | 2 +- > rust/kernel/lib.rs | 2 + > rust/kernel/sync/completion.rs | 42 +++- > rust/kernel/virtio.rs | 423 ++++++++++++++++++++++++++++++++++++++++ > rust/kernel/virtio/utils.rs | 57 ++++++ > rust/kernel/virtio/virtqueue.rs | 314 +++++++++++++++++++++++++++++ > samples/rust/Kconfig | 15 ++ > samples/rust/Makefile | 1 + > samples/rust/rust_virtio_rtc.rs | 403 ++++++++++++++++++++++++++++++++++++++ > 13 files changed, 1309 insertions(+), 2 deletions(-) > --- > base-commit: 028ef9c96e96197026887c0f092424679298aae8 > change-id: 20260504-rust-virtio-8523b01dfdc2 > > Best regards, > -- > Manos Pitsidianakis <[email protected]> > > -- > Manos Pitsidianakis > Emulation and Virtualization Engineer at Linaro Ltd