[PATCH] utils: test: show test name before running it

This way, the running test is visible. This helps for longer running or
freezed tests.

The log is now shown after the test name.

Signed-off-by: Hannes Diethelm <[email protected]>
---
 utils/evl-test | 13 +++++++------
 1 file changed, 7 insertions(+), 6 deletions(-)

diff --git a/utils/evl-test b/utils/evl-test
index fa3ef73..5139d09 100644
--- a/utils/evl-test
+++ b/utils/evl-test
@@ -83,22 +83,23 @@ result=0
 while : ; do
       for t in $test_list; do
 	  test \! -x $t && echo "$(basename $0): $(basename $t): no such test" && exit 2
+	  echo -n "$(basename $t):"
 	  # Swap stdout<->stderr for the test, capturing stderr into $log.
 	  log=$($t $test_arg_list 3>&1 1>&2 2>&3)
 	  status=$?
 	  if test $status = 43; then
-	      echo "$(basename $t): $log"
+	      echo " $log"
 	  else
-	      test -n "$log" && echo "$log"
 	      if test $status = 0; then
-		  echo "$(basename $t): OK"
+		  echo " OK"
 	      elif test $status = 42; then
-		  echo "$(basename $t): no kernel support"
+		  echo " no kernel support"
 	      else
-		  echo "** $(basename $t): BROKEN"
+		  echo " ** BROKEN"
 		  result=$status
-		  test x$keep_going = xfalse && break
 	      fi
+	      test -n "$log" && echo "$log"
+	      test $result -ne 0 && test x$keep_going = xfalse && break
 	  fi
       done
       test x$repeat = xfalse && break
-- 
2.47.3