[PATCH] pinctrl: meson: support gpio toggle command

From: Yang Xiwen <[email protected]>

meson_gpio_get() always assumes gpio is configured to input mode. This
is incorrect and breaks `gpio toggle` command:

gpio: pin aobus-banks2 (gpio 2) value is 0
   Warning: value of pin is still 1

Fix it by adding the logic to handle both input and output mode.

Fixes: 2009a8d03fe5 ("pinctrl: meson: add GPIO support")
Signed-off-by: Yang Xiwen <[email protected]>
---
 drivers/pinctrl/meson/pinctrl-meson.c | 21 ++++++++++++++++++++-
 1 file changed, 20 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index babf1bccc969..a1f4afd11f94 100644
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -117,8 +117,27 @@ int meson_gpio_get(struct udevice *dev, unsigned int offset)
 	struct meson_pinctrl *priv = dev_get_priv(dev->parent);
 	unsigned int reg, bit;
 	int ret;
+	enum gpio_func_t direction;
+	enum meson_reg_type reg_type;
 
-	ret = meson_gpio_calc_reg_and_bit(dev->parent, offset, REG_IN, &reg,
+	direction = meson_gpio_get_direction(dev, offset);
+
+	switch (direction) {
+	case GPIOF_INPUT:
+		reg_type = REG_IN;
+		break;
+
+	case GPIOF_OUTPUT:
+		reg_type = REG_OUT;
+		break;
+
+	default:
+		reg_type = REG_IN;
+		dev_warn(dev, "Failed to get current direction of Pin %u\n", offset);
+		break;
+	}
+
+	ret = meson_gpio_calc_reg_and_bit(dev->parent, offset, reg_type, &reg,
 					  &bit);
 	if (ret)
 		return ret;

---
base-commit: c5afa1fef49f55146e78d6157470520391c40eca
change-id: 20250617-meson_ppinctrl-5139ca06b828

Best regards,
-- 
Yang Xiwen <[email protected]>