Re: [PATCH v1 04/11] mm/memremap: add ZONE_DEVICE support for compound pages

On Thu, May 06, 2021 at 11:23:25AM +0100, Joao Martins wrote:
> >> I think it is ok for dax/nvdimm to continue to maintain their align
> >> value because it should be ok to have 4MB align if the device really
> >> wanted. However, when it goes to map that alignment with
> >> memremap_pages() it can pick a mode. For example, it's already the
> >> case that dax->align == 1GB is mapped with DEVMAP_PTE today, so
> >> they're already separate concepts that can stay separate.
> > 
> > devdax namespace with align of 1G implies we expect to map them with 1G
> > pte entries? I didn't follow when you say we map them today with
> > DEVMAP_PTE entries.
> 
> This sort of confusion is largelly why Dan is suggesting a @geometry for naming rather
> than @align (which traditionally refers to page tables entry sizes in pagemap-related stuff).
> 
> DEVMAP_{PTE,PMD,PUD} refers to the representation of metadata in base pages (DEVMAP_PTE),
> compound pages of PMD order (DEVMAP_PMD) or compound pages of PUD order (DEVMAP_PUD).
> 
> So, today:
> 
> * namespaces with align of 1G would use *struct pages of order-0* (DEVMAP_PTE) backed with
> PMD entries in the direct map.
> * namespaces with align of 2M would use *struct pages of order-0* (DEVMAP_PTE) backed with
> PMD entries in the direct map.
> 
> After this series:
> 
> * namespaces with align of 1G would use *compound struct pages of order-30* (DEVMAP_PUD)
> backed with PMD entries in the direct map.

order-18

> * namespaces with align of 1G would use *compound struct pages of order-21* (DEVMAP_PMD)
> backed with PTE entries in the direct map.

i think you mean "align of 2M", and order-9.

(note that these numbers are/can be different for powerpc since it
supports different TLB page sizes.  please don't get locked into x86
sizes, and don't ignore the benefits *to software* of managing memory
in sizes other than just those supported by the hardware).
_______________________________________________
Linux-nvdimm mailing list -- [email protected]
To unsubscribe send an email to [email protected]