[ath9k-devel] FW: Delete sta after scan

Hi,



 The following message iw event for QCA 11n card. Sometimes, the station gets deleted and automatically added in the driver. Sometime, the after the deletion of the station, the station did not get added. It always occurs after completion of scan. There is no message communication over the air like de-authentication packet either from AP or station. Is there specific reason ?

>
 1425735947.579066: wlan0 (phy #0): scan started
 1425735947.687011: wlan0 (phy #0): scan finished: 2462,
 1425735947.688237: wlan1 (phy #1): scan started
 1425735947.798659: wlan1 (phy #1): scan finished: 2462,
 1425735977.836133: wlan0 (phy #0): scan started
 1425735977.943734: wlan0 (phy #0): scan finished: 2412,
  1425735977.944865: wlan1 (phy #1): scan started
 1425735978.052711: wlan1 (phy #1): scan finished: 2412,

 1425735978.334949: wlan0: del station 08:11:96:a1:aa:84



 1425736008.078964: wlan0 (phy #0): scan started

 1425736008.186873: wlan0 (phy #0): scan finished: 2417,
 1425736008.188269: wlan1 (phy #1): scan started
 1425736008.298455: wlan1 (phy #1): scan finished: 2417


 Best Regards,

 Sunder