ath9k: Add a module parameter to invert LED polarity.

From: Vittorio Gambaletta (VittGam) <[email protected]>

commit cd84042ce9040ad038e958bc67a46fcfc015c736 upstream.

The LED can be active high instead of active low on some hardware.

Add the led_active_high module parameter. It defaults to -1 to obey
platform data as before.

Setting the parameter to 1 or 0 will force the LED respectively
active high or active low.

Cc: <[email protected]>
Cc: <[email protected]>
Cc: <[email protected]>
Signed-off-by: Vittorio Gambaletta <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>

---
 drivers/net/wireless/ath/ath9k/init.c |    7 +++++++
 1 file changed, 7 insertions(+)

--- a/drivers/net/wireless/ath/ath9k/init.c
+++ b/drivers/net/wireless/ath/ath9k/init.c
@@ -49,6 +49,10 @@ int ath9k_led_blink;
 module_param_named(blink, ath9k_led_blink, int, 0444);
 MODULE_PARM_DESC(blink, "Enable LED blink on activity");
 
+static int ath9k_led_active_high = -1;
+module_param_named(led_active_high, ath9k_led_active_high, int, 0444);
+MODULE_PARM_DESC(led_active_high, "Invert LED polarity");
+
 static int ath9k_btcoex_enable;
 module_param_named(btcoex_enable, ath9k_btcoex_enable, int, 0444);
 MODULE_PARM_DESC(btcoex_enable, "Enable wifi-BT coexistence");
@@ -600,6 +604,9 @@ static int ath9k_init_softc(u16 devid, s
 	if (ret)
 		return ret;
 
+	if (ath9k_led_active_high != -1)
+		ah->config.led_active_high = ath9k_led_active_high == 1;
+
 	/*
 	 * Enable WLAN/BT RX Antenna diversity only when:
 	 *


Patches currently in stable-queue which might be from linux-wireless at vittgam.net are

queue-4.5/ath9k-add-a-module-parameter-to-invert-led-polarity.patch
queue-4.5/ath9k-fix-led-polarity-for-some-mini-pci-ar9220-mb92-cards.patch