[ath9k-devel] [PATCH] ath9k: Update AR9340 initvals for txgain table mode 4

This is a 10dB transmit signal gain difference, right?

I can go poke someone on the PHY side and see if they have any ideas...


-a


On 20 May 2016 at 12:09, Alexander Couzens <[email protected]> wrote:
> On Fri, 20 May 2016 02:31:15 +0200
> Alexander Couzens <[email protected]> wrote:
>
>> Changing the table for 5Ghz HT20/HT40 to fix a 10dbm signal difference
>> on the client side when running LEDE on the AP (TpLink CPE510) instead
>> of the vendor driver. These values are taken from a TpLink CPE510
>> running the vendor firmware using a small script that retrieved the
>> same registers as already defined in the tx gain table.
>>
>> Signed-off-by: Alexander Couzens <[email protected]>
>
> The cpe510 has a second calib data, using that ones works quite well,
> because they are using 'TX Gain: 1' instead of the other table I
> patches in my last mail (Tx Gain 4').
> Please only see this patch as RFC and don't merge it right away.
>
> Thanks,
> lynxis
>
> --
> Alexander Couzens
>
> mail: lynxis at fe80.eu
> jabber: lynxis at fe80.eu
> mobile: +4915123277221
> gpg: 390D CF78 8BF9 AA50 4F8F  F1E2 C29E 9DA6 A0DF 8604
>
> _______________________________________________
> ath9k-devel mailing list
> ath9k-devel at lists.ath9k.org
> https://lists.ath9k.org/mailman/listinfo/ath9k-devel
>