[ath9k-devel] [RFC/RFT 1/5] mac80211: skip netdev queue control with software queuing

Hi Toke,

On Sat, Jun 4, 2016 at 2:51 AM, Toke H?iland-J?rgensen <[email protected]> wrote:
> From: Michal Kazior <[email protected]>
>
> Qdiscs are designed with no regard to 802.11
> aggregation requirements and hand out
> packet-by-packet with no guarantee they are
> destined to the same tid. This does more bad than
> good no matter how fairly a given qdisc may behave
> on an ethernet interface.
>
> Software queuing used per-AC netdev subqueue
> congestion control whenever a global AC limit was
> hit. This meant in practice a single station or
> tid queue could starve others rather easily. This
> could resonate with qdiscs in a bad way or could
> just end up with poor aggregation performance.
> Increasing the AC limit would increase induced
> latency which is also bad.
>
> Disabling qdiscs by default and performing
> taildrop instead of netdev subqueue congestion
> control on the other hand makes it possible for
> tid queues to fill up "in the meantime" while
> preventing stations starving each other.
>
> This increases aggregation opportunities and
> should allow software queuing based drivers
> achieve better performance by utilizing airtime
> more efficiently with big aggregates.
>
> Signed-off-by: Michal Kazior <[email protected]>

As this patch is passing through your hands, you need to add your
Signed-off-by too.

Thanks,

-- 
Julian Calaby

Email: julian.calaby at gmail.com
Profile: http://www.google.com/profiles/julian.calaby/