[ath9k-devel] MCI howto?
sandeep suresh <[email protected]>
| Newsgroups | org.ath9k.lists.ath9k-devel |
|---|---|
| Message-ID | <[email protected]> |
Thanks Adrian. In the meatime, can you share the link in FreeBSD where we can look into the code?Thanks.
Sandeep.
On Saturday, 4 June 2016 10:32 PM, Adrian Chadd <[email protected]> wrote:
i'm documenting more details in freebsd as I figure stuff out. I'll
write up a webpage with what I can glean from the drivers/headers.
-adrian
On 2 June 2016 at 21:44, sandeep suresh <[email protected]> wrote:
> Adrian, can you please share the details on the MCI protocol specifications?
> Thanks & regards
> Sandeep.
>
>
> On Sunday, 29 May 2016 11:44 PM, Adrian Chadd <[email protected]> wrote:
>
>
> hiya!
>
> I'm trying to bring up MCI bluetooth coexistence on the QCA9565 on
> FreeBSD. I'm having no end of trouble - it seems that no matter what I
> do, the bluetooth always wins and the wifi side disconnects when the
> bt does an active scan (HCI "inquiry".)
>
> Does anyone remember the deep and amusing details about MCI support
> and how to debug this? I'm sure it's something stupid, but my time at
> QCA involved 2-wire and 3-wire coex (which you can debug with a
> scope), not MCI :(
>
> Thanks!
>
>
> -adrian
> _______________________________________________
> ath9k-devel mailing list
> ath9k-devel at lists.ath9k.org
> https://lists.ath9k.org/mailman/listinfo/ath9k-devel
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.ath9k.org/pipermail/ath9k-devel/attachments/20160606/da46e236/attachment.htm