[ath9k-devel] antenna-chain selection in ath9k?

Hi,

I don't /think/ the CSI dump provides vectors establishing which
stream(s) appear on which antennas (ie, for stream TX 0, the
per-RX-antenna information.) It's just a magnitude value.

(I'm about to go pull down this stuff and look at it in more detail
because I just got Osprey location service stuff going in
linux/freebsd and the last bit is the CSI information..> :-)



-a


On 7 July 2016 at 12:19, Jeon <[email protected]> wrote:
> I am trying to measure and compare channel state information (CSI) with both
> ath9k (AR9000 802.11n series) and iwlwifi (Intel WiFi 5300)
>
> To extract CSI, I am using
> - ath9k: Atheros CSI Tool [1]
> - iwlwifi: linux 802.11n CSI tool [2]
>
> FAQ section of iwlwifi says that, it reports permutation vector. That is, a
> signal from an antenna 1 does not always go into an rx chain 1, it can go a
> chain 2 or 3 [3]. Permutation vector tells such information.
>
> What I wonder is, does it apply same to ath9k. Currently, [1] does not
> provide such information.
>
> Regards,
> Jeon.
>
> [1] http://pdcc.ntu.edu.sg/wands/Atheros/
> [2] http://dhalperi.github.io/linux-80211n-csitool/
> [3] http://dhalperi.github.io/linux-80211n-csitool/faq.html, item #2
>
> _______________________________________________
> ath9k-devel mailing list
> ath9k-devel at lists.ath9k.org
> https://lists.ath9k.org/mailman/listinfo/ath9k-devel
>