[ath9k-devel] [PATCH v5 1/3] Documentation: dt: net: add ath9k wireless device binding

On Sunday, August 21, 2016 4:31:03 PM CEST Martin Blumenstingl wrote:
> +pci {
> +       pcie at 0 {
> +               reg = <0 0 0 0 0>;

It's not clear what these two nodes refer to in the example. Is the top-level
node the PCI host bridge, and the second node the first PCIe port?

Maybe add the properties from a real system here to make this a little
clearer.

The unit address for the slot should be "00,0", not "0" here.

> +               #interrupt-cells = <1>;
> +               #size-cells = <2>;
> +               #address-cells = <3>;
> +               device_type = "pci";
> +

I think this needs an empty "ranges" property to be a valid bridge node.

> +               ath9k at 0,0 {

According to the PCI binding, the name should be the same as the
compatible string here, or match the class code in the table.

> +                       compatible = "pci168c,0030";
> +                       reg = <0 0 0 0 0>;

Are the device/fn numbers all zero on your system? This is a bit
confusing, as it's not immediately clear what the reg properties
refers to. Also, I think the length should reflect the actual length
of the config space, either 0x100 or 0x1000.

> +                       qca,disable-5ghz;
> +               };
> +       };
> +};

	Arnd