No subject

80         /* Enable radar pulse detection if on a DFS channel. Spectral
81          * scanning and radar detection can not be used concurrently.
82          */
83         if (hw->conf.radar_enabled) {
84                 u32 rxfilter;
85
86                 rxfilter = ath9k_hw_getrxfilter(ah);
87                 rxfilter |= ATH9K_RX_FILTER_PHYRADAR |
88                                 ATH9K_RX_FILTER_PHYERR;
89                 ath9k_hw_setrxfilter(ah, rxfilter);
90                 ath_dbg(common, DFS, "DFS enabled at freq %d\n",
91                         chan->center_freq);
92         } else {
93                 /* perform spectral scan if requested. */
94                 if (test_bit(ATH_OP_SCANNING, &common->op_flags) &&
95                         sc->spec_priv.spectral_mode == SPECTRAL_CHANSCAN)
96                         ath9k_cmn_spectral_scan_trigger(common, &sc->spec_priv);
97         }

it seems that spectral can't ever be activated while operating on a DFS channel.

If you need to catch the opposite case, i.e. prevent feeding pseudo-radar pulses
into the pattern detector, you just need to ensure that they depend on
hw->conf.radar_enabled. A patch like the attached one should be enough.


Cheers,
Zefir

--------------81DB7B8680E9662AC7B071A0
Content-Type: text/x-patch;
 name="0001-ath9k-feed-DFS-detector-only-if-operating-on-radar-c.patch"
Content-Transfer-Encoding: 7bit
Content-Disposition: attachment;
 filename*0="0001-ath9k-feed-DFS-detector-only-if-operating-on-radar-c.pa";
 filename*1="tch"