[PATCH v2 3/3] PCI/IOV: Restore initial VF ReBAR sizes on PF driver remove

sriov_disable() and sriov_enable() error paths restore the per-VF BAR
sizes saved at probe time. They do not cover the case where the PF
driver is detached while VF BARs were resized but SR-IOV was never
enabled (or was already disabled).

Restore the initial sizes from pci_iov_remove() as well. That hook runs
on driver detach while the device is still live, unlike sriov_release()
which runs later from the pci_dev release path.

Skip the restore when the PF driver leaves SR-IOV enabled; in that case
VF memory decoding is still active and pci_iov_vf_bar_set_size() cannot
safely change the VF BAR size.

Signed-off-by: Marcin Bernatowicz <[email protected]>
---
 drivers/pci/iov.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/pci/iov.c b/drivers/pci/iov.c
index 999938163ce9..3739825c84e9 100644
--- a/drivers/pci/iov.c
+++ b/drivers/pci/iov.c
@@ -1085,8 +1085,12 @@ void pci_iov_remove(struct pci_dev *dev)
 		return;
 
 	iov->driver_max_VFs = iov->total_VFs;
-	if (iov->num_VFs)
+	if (iov->num_VFs) {
 		pci_warn(dev, "driver left SR-IOV enabled after remove\n");
+		return;
+	}
+
+	sriov_restore_vf_rebar_initial_sizes(dev);
 }
 
 /**
-- 
2.43.0