Re: [PATCH 1/2] drm/i915/display: Enable AS SDP Skip Frames

On 8/4/2026 12:23 AM, Uma Shankar wrote:
> When Panel Replay is active the transcoder timing generator runs at the
> panel's maximum refresh rate, but content is often presented at a lower
> rate. In that case the Adaptive-Sync SDP (AS SDP) only needs to reach the
> panel often enough to satisfy its maximum frame time, so transmitting it
> on every frame is redundant and shows up as repeated SDPs on the link.
>
> Xe3LPD adds a HW skip-frame counter in PR_ALPM_CTL that lets the source
> send a single AS SDP and then suppress it for a programmed number of
> frames. Program this counter so that one AS SDP is followed by
> (max_vrefresh / flip_rate - 1) idle frames, matching the effective
> content rate and allowing the link to be driven down to as low as 1Hz
> when the hardware supports it.
>
> The maximum refresh rate is taken from the current mode's vertical
> refresh (adjusted_mode), while the actual flip/content rate is derived
> from the CMRR target (force_cmrr numerator in milli-Hz over the 1000 or
> 1001 denominator). If no CMRR target is programmed the skip counter is
> left at zero, i.e. the feature is a no-op and AS SDP continues to be sent
> on every frame.
>
> ToDo: Currently using CMRR debugfs as an interface to get the flip rate
> from userspace, this will be extended to a property interface to receive
> actual content fps as follow up.
>
> Assisted-by: Claude:claude-opus-4-8
> Signed-off-by: Uma Shankar <[email protected]>
> ---
>   drivers/gpu/drm/i915/display/intel_alpm.c     | 45 +++++++++++++++++++
>   drivers/gpu/drm/i915/display/intel_psr_regs.h |  2 +
>   2 files changed, 47 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_alpm.c b/drivers/gpu/drm/i915/display/intel_alpm.c
> index f1383764b702..0f98f02a1848 100644
> --- a/drivers/gpu/drm/i915/display/intel_alpm.c
> +++ b/drivers/gpu/drm/i915/display/intel_alpm.c
> @@ -375,6 +375,46 @@ static u32 get_pr_alpm_as_sdp_transmission_time(const struct intel_crtc_state *c
>   	}
>   }
>   
> +/*
> + * Periodic Adaptive-Sync SDP skip frames.
> + *
> + * While Panel Replay is active the transcoder timing generator runs at the
> + * panel's maximum refresh rate, but content may be presented at a lower rate.
> + * The Adaptive-Sync SDP only needs to reach the panel often enough to satisfy
> + * its maximum frame time, so transmitting it on every frame is unnecessary and
> + * shows up as repeated SDPs on the link. Program the HW skip counter so that a
> + * single AS SDP is followed by (max_vrefresh / flip_vrefresh - 1) idle frames,
> + * matching the effective content rate.
> + *
> + * ToDo: Actual flip rate is currently passed on by userspace through debugfs
> + * create for CMRRR, but will be extended later as a property interface.
> + */
> +static u32 intel_pr_as_sdp_skip_frames(const struct intel_crtc_state *crtc_state)
> +{
> +	struct intel_crtc *crtc = to_intel_crtc(crtc_state->uapi.crtc);
> +	int max_vrefresh = drm_mode_vrefresh(&crtc_state->hw.adjusted_mode);
> +	int flip_vrefresh;
> +	u32 skip_frames;
> +
> +	/*
> +	 * Actual (flip) refresh rate comes from the CMRR target: numerator is
> +	 * in milli-Hz, denominator is 1000 (1:1) or 1001 (1000/1001 timing).
> +	 */
> +	if (!crtc->force_cmrr.numerator || !crtc->force_cmrr.denominator)
> +		return 0;

I assume skip frames are valid only when crtc_state->vrr.cmrr.enable is true.
As intel_vrr_cmrr_compute_config() already validates the CMRR parameters before setting this flag,
I think checking crtc_state->vrr.cmrr.enable here should cover all the validations.

> +
> +	flip_vrefresh = DIV_ROUND_CLOSEST(crtc->force_cmrr.numerator,
> +					  crtc->force_cmrr.denominator);
> +
> +	if (max_vrefresh <= 0 || flip_vrefresh <= 0 || max_vrefresh <= flip_vrefresh)
> +		return 0;
> +
> +	skip_frames = max_vrefresh / flip_vrefresh - 1;
> +
> +	return min_t(u32, skip_frames,
> +		     REG_FIELD_MAX(PR_ALPM_CTL_AS_SDP_SKIP_FRAMES_MASK));
> +}
> +
>   static void lnl_alpm_configure(struct intel_dp *intel_dp,
>   			       const struct intel_crtc_state *crtc_state)
>   {
> @@ -410,6 +450,11 @@ static void lnl_alpm_configure(struct intel_dp *intel_dp,
>   			else
>   				pr_alpm_ctl &= ~PR_ALPM_CTL_USE_DC3CO_IDLE_PROTOCOL;
>   
> +			/* AS SDP skip frames field only exists on Xe3LPD+ */
> +			if (DISPLAY_VER(display) >= 35)
> +				pr_alpm_ctl |= PR_ALPM_CTL_AS_SDP_SKIP_FRAMES(
> +					intel_pr_as_sdp_skip_frames(crtc_state));
> +
>   			intel_de_write(display, PR_ALPM_CTL(display, cpu_transcoder),
>   				       pr_alpm_ctl);
>   		}
> diff --git a/drivers/gpu/drm/i915/display/intel_psr_regs.h b/drivers/gpu/drm/i915/display/intel_psr_regs.h
> index 16a9e3af198d..bb577e7e3bbd 100644
> --- a/drivers/gpu/drm/i915/display/intel_psr_regs.h
> +++ b/drivers/gpu/drm/i915/display/intel_psr_regs.h
> @@ -276,6 +276,8 @@
>   #define  PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1_OR_T2	REG_FIELD_PREP(PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_MASK, 0)
>   #define  PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1		REG_FIELD_PREP(PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_MASK, 1)
>   #define  PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T2		REG_FIELD_PREP(PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_MASK, 2)
> +#define  PR_ALPM_CTL_AS_SDP_SKIP_FRAMES_MASK			REG_GENMASK(27, 16)
> +#define  PR_ALPM_CTL_AS_SDP_SKIP_FRAMES(frames)			REG_FIELD_PREP(PR_ALPM_CTL_AS_SDP_SKIP_FRAMES_MASK, (frames))
>   
>   #define _ALPM_CTL_A	0x60950
>   #define ALPM_CTL(dev_priv, tran)	_MMIO_TRANS2(dev_priv, tran, _ALPM_CTL_A)