[PATCH v4 2/2] drm/nouveau/kms: guard NULL crtc in nv50_sor_atomic_disable()

From: Marek Czernohous <[email protected]>

nv50_sor_atomic_disable() unconditionally computes
nv50_head(nv_encoder->crtc) and dereferences the result a few lines
later.  nv_encoder->crtc is nouveau's own shadow pointer, set in
.atomic_enable and cleared at the end of .atomic_disable.
Commit f575f2bdb6c3 ("drm/nouveau/kms/nv50-: Remove (nv_encoder->crtc)
checks in ->disable callbacks") removed the NULL check here,
reasoning that the atomic helpers never call ->disable without a
crtc.  On NVAC (MCP79) under Wayland sessions (observed with Weston's
DRM backend and with labwc/wlroots) we have hit the NULL case in
practice during session teardown and VT switches: disable runs without
(or after) its matching enable, and because nv50_head() is
container_of(), the NULL does not stay NULL but becomes a bogus
non-NULL pointer, so the subsequent head dereferences fault and the
kernel oopses.

Restore the guard, as drm_WARN_ON_ONCE() instead of a silent return:
a NULL crtc here still indicates a state-tracking inconsistency that
should stay visible.  Return without touching the output; in this path
either enable never ran (nothing to tear down) or an earlier disable
already did the teardown, and the encoder release is handled by the
commit_tail release loop in both cases.  (That loop then rejects the
release of a never-acquired output with -EINVAL in the nvif layer,
which is harmless; the vanilla code oopsed before ever reaching it.)

The same inconsistent-state path can also leave the encoder without an
old connector state, in which case nv50_outp_get_old_connector()
returns NULL while the backlight teardown dereferenced it
unconditionally, so the oops would only have moved there.  Hoist the
guard above all of that and look at the old connector only after
checking it.

Fixes: f575f2bdb6c3 ("drm/nouveau/kms/nv50-: Remove (nv_encoder->crtc) checks in ->disable callbacks")
Cc: <[email protected]>
Tested-by: Fab Stz <[email protected]>
Assisted-by: Claude:claude-opus-4-7
Assisted-by: Claude:claude-opus-4-8
Assisted-by: Claude:claude-opus-5
Signed-off-by: Marek Czernohous <[email protected]>
---
 drivers/gpu/drm/nouveau/dispnv50/disp.c | 30 ++++++++++++++++++++-----
 1 file changed, 25 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/nouveau/dispnv50/disp.c b/drivers/gpu/drm/nouveau/dispnv50/disp.c
index 364227f5456f..f532b0ed8880 100644
--- a/drivers/gpu/drm/nouveau/dispnv50/disp.c
+++ b/drivers/gpu/drm/nouveau/dispnv50/disp.c
@@ -1565,16 +1565,36 @@ static void
 nv50_sor_atomic_disable(struct drm_encoder *encoder, struct drm_atomic_commit *state)
 {
 	struct nouveau_encoder *nv_encoder = nouveau_encoder(encoder);
-	struct nv50_head *head = nv50_head(nv_encoder->crtc);
+	struct nv50_head *head;
 #ifdef CONFIG_DRM_NOUVEAU_BACKLIGHT
-	struct nouveau_connector *nv_connector = nv50_outp_get_old_connector(state, nv_encoder);
+	struct nouveau_connector *nv_connector;
 	struct nouveau_drm *drm = nouveau_drm(nv_encoder->base.base.dev);
-	struct nouveau_backlight *backlight = nv_connector->backlight;
-	struct drm_dp_aux *aux = &nv_connector->aux;
+	struct nouveau_backlight *backlight;
 	int ret;
+#endif
 
+	/* nv_encoder->crtc is the driver's shadow pointer, set in
+	 * .atomic_enable (and by the boot-time hardware readback) and
+	 * cleared at the end of this function.  NULL here
+	 * means disable-without-enable or a double disable; bail before
+	 * container_of() turns it into a bogus head pointer (checking the
+	 * result would not work, container_of(NULL) is never NULL).  The
+	 * encoder release is handled by the commit_tail release loop, so
+	 * there is nothing to clean up here.
+	 */
+	if (drm_WARN_ON_ONCE(encoder->dev, !nv_encoder->crtc))
+		return;
+	head = nv50_head(nv_encoder->crtc);
+
+#ifdef CONFIG_DRM_NOUVEAU_BACKLIGHT
+	/* The same inconsistent-state path can leave us without an old
+	 * connector state, so check before touching it.
+	 */
+	nv_connector = nv50_outp_get_old_connector(state, nv_encoder);
+	backlight = nv_connector ? nv_connector->backlight : NULL;
 	if (backlight && backlight->uses_dpcd) {
-		ret = drm_edp_backlight_disable(aux, &backlight->edp_info);
+		ret = drm_edp_backlight_disable(&nv_connector->aux,
+						&backlight->edp_info);
 		if (ret < 0)
 			NV_ERROR(drm, "Failed to disable backlight on [CONNECTOR:%d:%s]: %d\n",
 				 nv_connector->base.base.id, nv_connector->base.name, ret);
-- 
2.54.0