[PATCH RESEND RFC 1/3] net: ath11k: fix redundant reset from stale pending workqueue bit

During a firmware lockup, WMI commands time out in rapid succession,
each calling queue_work() to schedule ath11k_core_reset().  This can
cause a spurious extra reset after recovery completes:

1. First WMI timeout calls queue_work(), sets the pending bit and
   schedules ath11k_core_reset(). The workqueue clears the pending bit
   before invoking the work function. reset_count becomes 1 and the reset
   is kicked off asynchronously. ath11k_core_reset() returns.

2. Second WMI timeout calls queue_work() and re-queues the work. When it
   runs after step 1 returns, it sees reset_count > 1 and blocks in
   wait_for_completion(). The pending bit is again cleared.

3. Third WMI timeout calls queue_work(), the pending bit was cleared in
   step 2, so this succeeds and arms another execution.

4. The asynchronous reset finishes. ath11k_mac_op_reconfig_complete()
   decrements reset_count and calls complete(). The blocked worker from
   step 2 wakes, takes the early-exit path, and decrements reset_count to
   0.

5. The workqueue sees the pending bit from step 3 and runs
   ath11k_core_reset() again. reset_count is 0, triggering a
   full redundant hardware reset.

Fix this by calling cancel_work() on reset_work in
ath11k_mac_op_reconfig_complete() before signalling completion. This
clears any stale pending bit, preventing the spurious re-execution.

Signed-off-by: Matthew Leach <[email protected]>
---
 drivers/net/wireless/ath/ath11k/mac.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index e4ee2ba1f669..748f779b3d1b 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -9274,6 +9274,10 @@ ath11k_mac_op_reconfig_complete(struct ieee80211_hw *hw,
 			 * the recovery has to be done for each radio
 			 */
 			if (recovery_count == ab->num_radios) {
+				/* Cancel any pending work, preventing a second redudant
+				 * reset.
+				 */
+				cancel_work(&ab->reset_work);
 				atomic_dec(&ab->reset_count);
 				complete(&ab->reset_complete);
 				ab->is_reset = false;

-- 
2.53.0