[PATCH v2 4/7] arm64: dts: qcom: milos: Split up uart11 pinctrl
Luca Weiss <[email protected]>
| Newsgroups | org.infradead.lists.ath11k,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-bluetooth,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-wireless,org.kernel.vger.phone-devel |
|---|---|
| Message-ID | <[email protected]> |
In order to set the pinctrl for the individual CTS, RTS, TX and RX pins, split up the pinctrl configuration into 4 nodes so that boards can set some properties separately. Signed-off-by: Luca Weiss <[email protected]> --- arch/arm64/boot/dts/qcom/milos.dtsi | 28 ++++++++++++++++++---------- 1 file changed, 18 insertions(+), 10 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/milos.dtsi b/arch/arm64/boot/dts/qcom/milos.dtsi index 4a64a98a434b..71292dfd6e08 100644 --- a/arch/arm64/boot/dts/qcom/milos.dtsi +++ b/arch/arm64/boot/dts/qcom/milos.dtsi @@ -2099,19 +2099,27 @@ qup_i2c7_data_clk: qup-i2c7-data-clk-state { }; qup_uart11_cts_rts: qup-uart11-cts-rts-state { - /* CTS, RTS */ - pins = "gpio48", "gpio49"; - function = "qup1_se4"; - drive-strength = <2>; - bias-pull-down; + qup_uart11_cts: cts-pins { + pins = "gpio48"; + function = "qup1_se4"; + }; + + qup_uart11_rts: rts-pins { + pins = "gpio49"; + function = "qup1_se4"; + }; }; qup_uart11_default: qup-uart11-default-state { - /* TX, RX */ - pins = "gpio50", "gpio51"; - function = "qup1_se4"; - drive-strength = <2>; - bias-pull-up; + qup_uart11_tx: tx-pins { + pins = "gpio50"; + function = "qup1_se4"; + }; + + qup_uart11_rx: rx-pins { + pins = "gpio51"; + function = "qup1_se4"; + }; }; sdc2_default: sdc2-default-state { -- 2.53.0