[PATCH ath-next 2/2] wifi: ath11k: Correctly copy the hint BSSID in WMI scan request

Currently, in ath11k_wmi_send_scan_start_cmd(), the logic to populate
the hint_bssid copies the BSSID in the wrong direction, from the
firmware message to the argument buffer. Swap the parameters so that
the BSSID is correctly populated in the firmware message from the
argument buffer.

This issue was reported on ath12k, but exists in ath11k as well.

Compile tested only.

Reported-by: Baochen Qiang <[email protected]>
Closes: https://lore.kernel.org/linux-wireless/[email protected]/
Fixes: 74601ecfef6e ("ath11k: Add support for 6g scan hint")
Assisted-by: Claude:claude-sonnet-4-6
Signed-off-by: Jeff Johnson <[email protected]>
---
 drivers/net/wireless/ath/ath11k/wmi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c
index dca6e011cc40..c54f50b98a13 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -2423,8 +2423,8 @@ int ath11k_wmi_send_scan_start_cmd(struct ath11k *ar,
 		for (i = 0; i < params->num_hint_bssid; ++i) {
 			hint_bssid->freq_flags =
 				params->hint_bssid[i].freq_flags;
-			ether_addr_copy(&params->hint_bssid[i].bssid.addr[0],
-					&hint_bssid->bssid.addr[0]);
+			ether_addr_copy(&hint_bssid->bssid.addr[0],
+					&params->hint_bssid[i].bssid.addr[0]);
 			hint_bssid++;
 		}
 	}

-- 
2.43.0