Re: [PATCH 2/2] dt-bindings: wireless: ath: Deprecate 'qcom,calibration-variant' property

On Fri, Nov 14, 2025 at 11:47:25AM +0100, Krzysztof Kozlowski wrote:
> On 14/11/2025 11:22, Manivannan Sadhasivam wrote:
> > On devicetree platforms, ath{10k/11k} drivers rely on the presence of the
> > 'qcom,calibration-variant' property to select the correct calibration data
> > for device variants with colliding IDs.
> > 
> > But this property based selection has its own downside that it needs to be
> > added to the devicetree node of the WLAN device, especially for PCI based
> > devices. Currently, the users/vendors are forced to hardcode this property
> > in the PCI device node. If a different device need to be attached to the
> > slot, then the devicetree node also has to be changed. This approach is not
> > scalable and creates a bad user experience.
> > 
> > So deprecate this property from WLAN devicetree nodes and let the drivers
> > do the devicetree model based calibration variant lookup using a static
> > table.
> > 
> > This also warrants removing the property from examples in the binding.
> > 
> > Signed-off-by: Manivannan Sadhasivam <[email protected]>
> > ---
> 
> The problem - visible in one of the examples here - is that one board
> has multiple WiFi chips and they use different calibration-variant
> properties. How do you find the right calibration variant for such case
> based on board machine match?
> 

I suspect the legitimacy of the example here. I don't understand how a single
machine can have same devices with 3 different calibration data.

AFAIU, calibration data is specific to the platform design. And I don't see any
upstream supported devicetree having similar properties.

- Mani

-- 
மணிவண்ணன் சதாசிவம்