[PATCH 0/2] ath11k: support IPQ9574

Hi,

This is my attempt to make ath11k work on IPQ9574. IPQ9574 is intended
for wifi-7 devices, so it seems the exception rather than the rule to
pair it with a wifi-6 chip. That's exactly what my Archer BE550 does.

This consists of a wifi-6 (QCN5024) chip connected via PCIe to the
SoC, but exposed to the OS via AHB. The Q6 firmware [4] requires
remoteproc support introduced in a separate series [3]. The QMI
firmware interface is very similar to IPQ6018, such that almost no
new code is needed.

I am not including the wifi@c000000 devicetree node in this series, as
it depends on nodes from the remoteproc series [3].

I have been successfully doogfooding this for a few of weeks in AP mode.
There dependencies to this series. [2] is a compile-time dependency,
whereas [1] and [3] are needed for full functionality. I was adivsed to
leave [1] and [2] as separate patches and not add them to this series.


[1] https://lore.kernel.org/ath11k/[email protected]/
[2] https://lore.kernel.org/ath11k/[email protected]/
[3] https://lore.kernel.org/linux-remoteproc/[email protected]/
[4] https://github.com/quic/upstream-wifi-fw

Alexandru Gagniuc (2):
  dt: bindings: net: ath11k: add IPQ9574 compatible
  wifi: ath11k: support ipq9574

 .../bindings/net/wireless/qcom,ath11k.yaml    |  3 +
 drivers/net/wireless/ath/ath11k/ahb.c         |  4 +
 drivers/net/wireless/ath/ath11k/core.c        | 82 +++++++++++++++++++
 drivers/net/wireless/ath/ath11k/core.h        |  1 +
 drivers/net/wireless/ath/ath11k/hw.c          | 51 ++++++++++++
 drivers/net/wireless/ath/ath11k/hw.h          |  1 +
 6 files changed, 142 insertions(+)

-- 
2.45.1