Re: [PATCH v8 07/14] remoteproc: qcom: Select QCOM_PAS generic service
Konrad Dybcio <[email protected]>
| Newsgroups | org.infradead.lists.ath12k,org.freedesktop.lists.dri-devel,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel,org.kernel.vger.linux-media,org.kernel.vger.linux-remoteproc,org.kernel.vger.linux-wireless,org.kernel.vger.netdev,org.trustedfirmware.lists.op-tee |
|---|---|
| Message-ID | <[email protected]> |
On 6/26/26 3:34 PM, Sumit Garg wrote: > From: Sumit Garg <[email protected]> > > Select PAS generic service driver to enable support for multiple PAS > backends like OP-TEE in addition to SCM. > > Tested-by: Mukesh Ojha <[email protected]> # Lemans > Tested-by: Vignesh Viswanathan <[email protected]> # IPQ9650 > Signed-off-by: Sumit Garg <[email protected]> > --- > drivers/remoteproc/Kconfig | 4 +++- > 1 file changed, 3 insertions(+), 1 deletion(-) > > diff --git a/drivers/remoteproc/Kconfig b/drivers/remoteproc/Kconfig > index c521c744e7db..65befdbfa5f7 100644 > --- a/drivers/remoteproc/Kconfig > +++ b/drivers/remoteproc/Kconfig > @@ -210,6 +210,7 @@ config QCOM_Q6V5_MSS > select QCOM_Q6V5_COMMON > select QCOM_RPROC_COMMON > select QCOM_SCM > + select QCOM_PAS This is a NOP, SCM already requires QCOM_PAS > help > Say y here to support the Qualcomm self-authenticating modem > subsystem based on Hexagon V5. The TrustZone based system is > @@ -230,6 +231,7 @@ config QCOM_Q6V5_PAS > select QCOM_Q6V5_COMMON > select QCOM_RPROC_COMMON > select QCOM_SCM > + select QCOM_PAS Likewise > help > Say y here to support the TrustZone based Peripheral Image Loader for > the Qualcomm remote processors. This is commonly used to control > @@ -282,7 +284,7 @@ config QCOM_WCNSS_PIL > select QCOM_MDT_LOADER > select QCOM_PIL_INFO > select QCOM_RPROC_COMMON > - select QCOM_SCM > + select QCOM_PAS This is OK _however_ It leads to a situation where no back-ends can be enabled Konrad