[PATCH 1/6] b43: add d11 core revision 0x16 to id table

Add d11 core revision 0x16 (= 22) to the b43 bcma device id table.

The b43 bcma id table covers d11 revisions 0x11, 0x15, 0x17, 0x18,
0x1C, 0x1D, 0x1E, 0x28 and 0x2A. Revision 0x16 belongs to the same
N-PHY family as revisions 0x17 and 0x18 (radio 2057) and needs no
new PHY or radio code beyond the radio_rev 8 dispatcher entries
added later in this series - only the device id entry is missing.
Without it bcma scan enumerates the 802.11 core but no driver binds.

The revision is used by the Broadcom BCM6362 single-die integrated
2.4 GHz wireless block found in xDSL SoCs.

Signed-off-by: Alessio Ferri <[email protected]>
---
 drivers/net/wireless/broadcom/b43/main.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/net/wireless/broadcom/b43/main.c b/drivers/net/wireless/broadcom/b43/main.c
index b0e6aeb0b..673a56c30 100644
--- a/drivers/net/wireless/broadcom/b43/main.c
+++ b/drivers/net/wireless/broadcom/b43/main.c
@@ -117,6 +117,7 @@ MODULE_PARM_DESC(allhwsupport, "Enable support for all hardware (even it if over
 static const struct bcma_device_id b43_bcma_tbl[] = {
 	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x11, BCMA_ANY_CLASS),
 	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x15, BCMA_ANY_CLASS),
+	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x16, BCMA_ANY_CLASS),
 	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x17, BCMA_ANY_CLASS),
 	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x18, BCMA_ANY_CLASS),
 	BCMA_CORE(BCMA_MANUF_BCM, BCMA_CORE_80211, 0x1C, BCMA_ANY_CLASS),
-- 
2.43.0


Il 18/05/2026 03:49, Alessio Ferri ha scritto:
> This series completes b43 support for the Broadcom N-PHY revision 8
> paired with radio 2057 revision 8. b43 already supports the surrounding
> PHY family - N-PHY rev 8 with radio 2057 rev 5 and rev 7 are handled,
> and rev 16 with radio 2057 rev 9 is handled - but the rev 8 + rev 8
> combination falls through four dispatcher gaps:
> 
>   - radio_2057.c, r2057_upload_inittabs(), case 8 lists radio_rev 5
>     and 7 only;
>   - radio_2057.c, r2057_get_chantabent_rev7(), case 8 lists radio_rev
>     5 only;
>   - tables_nphy.c, b43_nphy_get_ipa_gain_table(), case 8 lists
>     radio_rev 5 only;
>   - radio_2057.c carries r2057_rev8_init[] as a 54-entry stub commented
>     out with "TODO: Which devices should use it?".
> 
> Two further pieces of plumbing are needed to reach those dispatchers
> in the first place: d11 core revision 0x16 is missing from the b43
> bcma id table, and the corerev 22 / radio 2057 combination needs the
> 24-bit indirect radio access path that brcmsmac uses for the same
> silicon generation (see brcmsmac/phy/phy_cmn.c read_radio_reg() /
> write_radio_reg()).
> 
> The series:
> 
>   1/6  b43: add d11 core revision 0x16 to id table
>   2/6  b43: route d11 corerev 22 to 24-bit indirect radio access
>   3/6  b43: support radio 2057 rev 8
>   4/6  b43: add IPA TX gain table for N-PHY r8 + radio 2057 r8
>   5/6  b43: add channel info table for N-PHY r8 + radio 2057 r8
>   6/6  b43: add RF power offset for N-PHY r8 + radio 2057 r8
> 
> Patches are ordered so that each one fixes the next visible failure
> in bring-up: 1/6 makes b43 bind to the core, 2/6 lets phy versioning
> read coherent radio identifiers, 3/6 unblocks the boot-time radio
> calibration that otherwise stalls the PSM at microcode startup, and
> 4/6-6/6 fill the remaining 2.4 GHz dispatcher entries so
> b43_nphy_set_channel completes to the default channel and core_init
> proceeds past PHY init.
> 
> Tested on a D-Link DSL-3580L (Broadcom BCM6362 SoC, single-die 2.4 GHz
> N-PHY rev 8 + radio 2057 rev 8 in 2.4 GHz IPA mode). The chip is in
> service worldwide in xDSL CPE devices.
> 
> b43 is currently Orphan in MAINTAINERS. These patches do not add a
> new chip family or PHY infrastructure; they fill four explicit
> dispatcher gaps for a combination of an already-supported PHY and
> an already-supported radio.
> 
> Alessio Ferri (6):
>   b43: add d11 core revision 0x16 to id table
>   b43: route d11 corerev 22 to 24-bit indirect radio access
>   b43: support radio 2057 rev 8
>   b43: add IPA TX gain table for N-PHY r8 + radio 2057 r8
>   b43: add channel info table for N-PHY r8 + radio 2057 r8
>   b43: add RF power offset for N-PHY r8 + radio 2057 r8
> 
>  drivers/net/wireless/broadcom/b43/main.c      |  10 +-
>  .../net/wireless/broadcom/b43/radio_2057.c    | 230 ++++++++++++++++--
>  .../net/wireless/broadcom/b43/tables_nphy.c   |  58 +++++
>  3 files changed, 280 insertions(+), 18 deletions(-)
> 


_______________________________________________
b43-dev mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/b43-dev