[PATCH 3/3] arm: socfpga: axe5-eagle: always use UART0

Configuring debug_ll with the UART from the configuration, while
configuring the PBL console with a hard-coded address may lead to
inconsistencies and confusion.

Avoid this by explicitly configuring debug_ll with a UART defined by the
board low level code.

While at it, replace the address with the UART port macro.

Signed-off-by: Michael Tretter <[email protected]>
---
 arch/arm/boards/arrow-axe5-eagle/lowlevel.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boards/arrow-axe5-eagle/lowlevel.c b/arch/arm/boards/arrow-axe5-eagle/lowlevel.c
index f946a8b9f616..b0a2d6673e0f 100644
--- a/arch/arm/boards/arrow-axe5-eagle/lowlevel.c
+++ b/arch/arm/boards/arrow-axe5-eagle/lowlevel.c
@@ -15,10 +15,12 @@ extern char __dtb_z_socfpga_agilex5_axe5_eagle_start[];
 
 static noinline void axe5_eagle_continue(void)
 {
+	void __iomem *uart = IOMEM(SOCFPGA_UART_BASE(0));
+
 	agilex5_clk_init();
 
-	socfpga_uart_setup_ll();
-	pbl_set_putc(socfpga_uart_putc, (void *) SOCFPGA_UART0_ADDRESS);
+	socfpga_uart_setup(uart);
+	pbl_set_putc(socfpga_uart_putc, uart);
 
 	pr_debug("Lowlevel init done\n");
 

-- 
2.47.3