Re: [PATCH v4 1/8] drm/connector: report out-of-band IRQ_HPD events

Hi,

On Mon, Jun 08, 2026 at 12:33:02AM +0300, Dmitry Baryshkov wrote:
> The DisplayPort standard defines a special kind of events called IRQ.
> These events are used to notify DP Source about the events on the Sink
> side. It is extremely important for DP MST handling, where the MST
> events are reported through this IRQ.
> 
> In case of the USB-C DP AltMode there is no actual HPD pulse, but the
> events are reported through the bits in the AltMode VDOs.
> 
> Rename drm_connector_oob_hotplug_event() to drm_connector_dp_oob_status()
> and extend its interface to report IRQ events to the DisplayPort Sink
> drivers.
> 
> Acked-by: Heikki Krogerus <[email protected]>
> Signed-off-by: Dmitry Baryshkov <[email protected]>
> ---
>  drivers/gpu/drm/drm_connector.c          | 20 ++++++++++++--------
>  drivers/usb/typec/altmodes/displayport.c | 23 +++++++++++++++--------
>  include/drm/drm_connector.h              | 21 +++++++++++++++++++--
>  3 files changed, 46 insertions(+), 18 deletions(-)
> 
> diff --git a/drivers/gpu/drm/drm_connector.c b/drivers/gpu/drm/drm_connector.c
> index 3fa4d2082cd7..bb128dd0263a 100644
> --- a/drivers/gpu/drm/drm_connector.c
> +++ b/drivers/gpu/drm/drm_connector.c
> @@ -3502,20 +3502,24 @@ struct drm_connector *drm_connector_find_by_fwnode(struct fwnode_handle *fwnode)
>  }
>  
>  /**
> - * drm_connector_oob_hotplug_event - Report out-of-band hotplug event to connector
> + * drm_connector_dp_oob_status - Report out-of-band hotplug event to DisplayPort connector
>   * @connector_fwnode: fwnode_handle to report the event on
>   * @status: hot plug detect logical state
> + * @extra_status: additional information provided by the sink without changing
> + * the HPD state (or in addition to such a change).
>   *
> - * On some hardware a hotplug event notification may come from outside the display
> - * driver / device. An example of this is some USB Type-C setups where the hardware
> - * muxes the DisplayPort data and aux-lines but does not pass the altmode HPD
> - * status bit to the GPU's DP HPD pin.
> + * In some cases when DisplayPort signals are being routed through the USB
> + * Type-C port the hotplug event notifications come from outside of the display
> + * driver / device. In this case hardware muxes the DisplayPort data and
> + * AUX-lines but does not pass the altmode HPD status bit to the GPU's DP HPD
> + * pin.
>   *
>   * This function can be used to report these out-of-band events after obtaining
>   * a drm_connector reference through calling drm_connector_find_by_fwnode().
>   */
> -void drm_connector_oob_hotplug_event(struct fwnode_handle *connector_fwnode,
> -				     enum drm_connector_status status)
> +void drm_connector_dp_oob_status(struct fwnode_handle *connector_fwnode,
> +				 enum drm_connector_status status,
> +				 enum drm_connector_status_extra extra_status)

Thanks for the renaming, but I think we can also rename
drm_connector_status_extra to something a bit more descriptive now?
drm_connector_dp_oob_event? status?

The rest looks good.

Maxime

_______________________________________________
linux-amlogic mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-amlogic

-----BEGIN PGP SIGNATURE-----

iJUEABMJAB0WIQTkHFbLp4ejekA/qfgnX84Zoj2+dgUCaigTAQAKCRAnX84Zoj2+
dnv2AX9le3hz+Lu8gxYvgEXc1sDIBCPM1bh/zkVwBN3wZ9THVMA3l8RMscsHED+I
ZdjXquUBeQESub4sfU2kH0nggZa7VB2wC1SqcPxTrCSdEwKVl5n4RlSMJ/F47hOK
i6kZa+CMlQ==
=wSKV
-----END PGP SIGNATURE-----