[PATCH v9 4/6] thermal: khadas-mcu-fan: Add fan config from platform data Add regulator support

Ronald Claveau via B4 Relay <[email protected]>
Newsgroups org.infradead.lists.linux-amlogic,dev.linux.lists.mfd,org.infradead.lists.linux-arm-kernel,org.kernel.feeds.b4-sent,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-i2c,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pm
Message-ID <[email protected]>
From: Ronald Claveau <[email protected]>

Replace the hardcoded MAX_LEVEL constant and fan register
with values read from platform_data (fan_reg, levels[] and nlevels),
as new MCUs need different values.

The cooling device's state is stored as an index into levels[],
and khadas_mcu_fan_set_level() writes levels[state] to fan_reg,
rather than writing the raw state value as before.

Optionally acquire and enable a "fan" regulator supply
at probe time and on resume,
so boards that gate fan power through a regulator are handled.

Reviewed-by: Neil Armstrong <[email protected]>
Signed-off-by: Ronald Claveau <[email protected]>
---
 drivers/thermal/khadas_mcu_fan.c | 58 ++++++++++++++++++++++++++++------------
 1 file changed, 41 insertions(+), 17 deletions(-)

diff --git a/drivers/thermal/khadas_mcu_fan.c b/drivers/thermal/khadas_mcu_fan.c
index 21b3d0a71bd0d..c7f74394b823f 100644
--- a/drivers/thermal/khadas_mcu_fan.c
+++ b/drivers/thermal/khadas_mcu_fan.c
@@ -13,34 +13,30 @@
 #include <linux/regmap.h>
 #include <linux/sysfs.h>
 #include <linux/thermal.h>
-
-#define MAX_LEVEL 3
+#include <linux/regulator/consumer.h>
 
 struct khadas_mcu_fan_ctx {
 	struct khadas_mcu *mcu;
+	unsigned int fan_reg;
 	unsigned int level;
+	const unsigned int *levels;
+	unsigned int nlevels;
 	struct thermal_cooling_device *cdev;
+	struct regulator *power;
 };
 
 static int khadas_mcu_fan_set_level(struct khadas_mcu_fan_ctx *ctx,
 				    unsigned int level)
 {
-	int ret;
-
-	ret = regmap_write(ctx->mcu->regmap, KHADAS_MCU_CMD_FAN_STATUS_CTRL_REG,
-			   level);
-	if (ret)
-		return ret;
-
-	ctx->level = level;
-
-	return 0;
+	return regmap_write(ctx->mcu->regmap, ctx->fan_reg, level);
 }
 
 static int khadas_mcu_fan_get_max_state(struct thermal_cooling_device *cdev,
 					unsigned long *state)
 {
-	*state = MAX_LEVEL;
+	struct khadas_mcu_fan_ctx *ctx = cdev->devdata;
+
+	*state = ctx->nlevels - 1;
 
 	return 0;
 }
@@ -60,14 +56,21 @@ khadas_mcu_fan_set_cur_state(struct thermal_cooling_device *cdev,
 			     unsigned long state)
 {
 	struct khadas_mcu_fan_ctx *ctx = cdev->devdata;
+	int ret;
 
-	if (state > MAX_LEVEL)
+	if (state >= ctx->nlevels)
 		return -EINVAL;
 
 	if (state == ctx->level)
 		return 0;
 
-	return khadas_mcu_fan_set_level(ctx, state);
+	ret = khadas_mcu_fan_set_level(ctx, ctx->levels[state]);
+	if (ret)
+		return ret;
+
+	ctx->level = state;
+
+	return 0;
 }
 
 static const struct thermal_cooling_device_ops khadas_mcu_fan_cooling_ops = {
@@ -78,6 +81,7 @@ static const struct thermal_cooling_device_ops khadas_mcu_fan_cooling_ops = {
 
 static int khadas_mcu_fan_probe(struct platform_device *pdev)
 {
+	const struct khadas_mcu_fan_pdata *pdata = dev_get_platdata(&pdev->dev);
 	struct khadas_mcu *mcu = dev_get_drvdata(pdev->dev.parent);
 	struct thermal_cooling_device *cdev;
 	struct device *dev = &pdev->dev;
@@ -87,7 +91,22 @@ static int khadas_mcu_fan_probe(struct platform_device *pdev)
 	ctx = devm_kzalloc(dev, sizeof(*ctx), GFP_KERNEL);
 	if (!ctx)
 		return -ENOMEM;
+
 	ctx->mcu = mcu;
+	ctx->fan_reg = pdata->fan_reg;
+	ctx->levels = pdata->levels;
+	ctx->nlevels = pdata->nlevels;
+
+	ctx->power = devm_regulator_get(dev->parent, "fan");
+	if (IS_ERR(ctx->power))
+		return PTR_ERR(ctx->power);
+
+	ret = regulator_enable(ctx->power);
+	if (ret) {
+		dev_err(dev, "Failed to enable fan power supply: %d\n", ret);
+		return ret;
+	}
+
 	platform_set_drvdata(pdev, ctx);
 
 	cdev = devm_thermal_of_child_cooling_device_register(dev->parent,
@@ -125,14 +144,19 @@ static int khadas_mcu_fan_suspend(struct device *dev)
 
 	ctx->level = level_save;
 
-	return 0;
+	return regulator_disable(ctx->power);
 }
 
 static int khadas_mcu_fan_resume(struct device *dev)
 {
 	struct khadas_mcu_fan_ctx *ctx = dev_get_drvdata(dev);
+	int ret;
+
+	ret = regulator_enable(ctx->power);
+	if (ret)
+		return ret;
 
-	return khadas_mcu_fan_set_level(ctx, ctx->level);
+	return khadas_mcu_fan_set_level(ctx, ctx->levels[ctx->level]);
 }
 #endif
 

-- 
2.49.0



_______________________________________________
linux-amlogic mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-amlogic
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.