Re: [PATCH] pinctrl: meson: a4: Add input enable pin configuration
Linus Walleij <[email protected]>
| Newsgroups | org.infradead.lists.linux-amlogic,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <CAD++jLneywcc-c01_T+gn0B8R0eS-8L-uZaQFLFAP76d-+rMag@mail.gmail.com> |
On Wed, Aug 12, 2026 at 12:18 PM Xianwei Zhao via B4 Relay <[email protected]> wrote: > From: Xianwei Zhao <[email protected]> > > Add support for PIN_CONFIG_INPUT_ENABLE in the Amlogic A4 pinctrl > driver. > > Use the existing output enable control to configure the input enable > state, since the hardware uses the same control with inverse semantics. > > Also update PIN_CONFIG_OUTPUT_ENABLE handling to return the actual > output enable state instead of treating any non-zero value as enabled. > > Signed-off-by: Xianwei Zhao <[email protected]> I just applied this because we are close to the merge window and it seems important and looks good to me. I can always pull it out if the maintainers object. Yours, Linus Walleij _______________________________________________ linux-amlogic mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-amlogic