Re: [PATCH v3 1/2] arm64: dts: qcom: qcs6490-rubikpi3: Add 3.3 V output supply
Konrad Dybcio <[email protected]>
| Newsgroups | org.infradead.lists.linux-arm-kernel,dev.linux.lists.imx,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
On 8/12/26 4:22 AM, Hongyang Zhao wrote: > Describe the GPIO-controlled VCC3V3_OUTPUT rail. This board-level rail > supplies the two camera connectors and the 40-pin expansion header. > > Keep the rail enabled because expansion-header consumers are not > represented in the Device Tree. > > Reviewed-by: Bryan O'Donoghue <[email protected]> > Signed-off-by: Hongyang Zhao <[email protected]> > --- Reviewed-by: Konrad Dybcio <[email protected]> Konrad