Re: [PATCH v6 0/5] i3c: Improve CCC reliability with actual_len, validation, and Direct GET retry

On Wed, Jul 08, 2026 at 12:17:36AM -0700, [email protected] wrote:
> From: Tze Yee Ng <[email protected]>
> 
> This series improves I3C Common Command Code (CCC) handling in the I3C
> core and master drivers. It separates requested and received GET payload
> lengths, validates GET responses centrally, and retries failed Direct GET
> CCCs once by default.
> 
> The DesignWare I3C master driver reports standard I3C M0/M2 error codes so
> the core can decide when a retry is appropriate. Variable-length GET CCC
> rules (GETMRL, GETMXDS) are described by callers via optional_bytes.
> 
> Patch 1/5 adds actual_len to struct i3c_ccc_cmd_payload.
> 
> Patch 2/5 has all I3C master drivers set actual_len on successful GET
> transfers and updates core GET helpers to interpret results from actual_len
> instead of len.
> 
> Patch 3/5 maps DesignWare CCC hardware errors to I3C M0/M2. M2 is reported
> only for broadcast address-header NACK (7'h7E). Target address NACK
> returns -EIO.
> 
> Patch 4/5 adds retries to struct i3c_ccc_cmd, validates GET payload length
> in i3c_master_send_ccc_cmd_locked() after a successful transfer, and
> retries failed Direct GET CCCs when the driver reports failure or an I3C
> error. Validation failures are not retried.
> 
> Patch 5/5 adds optional_bytes so callers describe variable-length GET CCC
> responses. GETMRL and GETMXDS set optional_bytes at the call site.
> 
> Changes in v6:
> - Fix ADI and Cadence GET actual_len: store hardware-reported xfer bytes
>   in cmd->rx_len and set actual_len from that, not from payload.len.
> - Fix Renesas GET actual_len: drain the response FIFO at rx_buf + rx_count
>   in resp_isr, clamp rx_count to data_len before subtracting (avoids
>   unsigned underflow when rx_isr reads round up to 32-bit words), and
>   report actual_len from cmd->rx_count.
> - Fix dw_i3c_ccc_set() to use dw_i3c_ccc_map_err() so SET CCCs get the
>   same M0/M2 mapping as GET.
> 
> Changes in v5:
> - Split the series into five patches for clearer review:
>   actual_len API, driver/core adoption, DW error mapping, core validation/
>   retry, and optional_bytes.
> - Fix regression in v4 patch 1: keep actual_len assignment in
>   dw_i3c_ccc_get(), not dw_i3c_ccc_set().
> - Move actual_len adoption in drivers/i3c/master.c into patch 2 so patch 2
>   matches its title and works on its own.
> - Split optional_bytes into its own patch (5/5); patch 4/5 adds strict
>   exact-length validation and retry only.
> - Do not retry on validation failure; retry only on driver/I3C errors.
> - Reset actual_len before each GET retry only when cmd->rnw is set.
> - Add @retries kernel-doc for struct i3c_ccc_cmd.
> - Simplify i3c_ccc_validate_payload_len() per review (drop redundant
>   exact-length check when optional_bytes == 0).
> - Clarify GETMXDS fallback comment: with optional_bytes = 3, a 2-byte
>   success on the first attempt no longer needs the shorter retry path.
> - Add Reviewed-by: Alexandre Mergnat on patch 3/5.
> 
> Changes in v4:
> - Add actual_len to keep requested and received lengths separate.
> - Map M2 only for broadcast-address NACK; not for target-address NACK.
> - Replace CCC-ID-specific validation with generic actual_len /
>   optional_bytes checks.
> - Retry Direct GET CCCs on any error (default once), not only M0/M2.
> - Add optional_bytes and cmd->retries to ccc.h; drop req_len and
>   payload.len save/restore in the core.
> - Update SVC, Cadence, ADI, Renesas, and MIPI HCI master drivers.
> 
> Changes in v3:
> - In dw_i3c_master_end_xfer_locked(), move RESPONSE_ERROR_ADDRESS_NACK to
>   return -EIO.
> 
> Changes in v2:
> - Split the monolithic patch into three patches (per review feedback).
> - Move GET payload validation and CCC retry from the DW driver to
>   drivers/i3c/master.c.
> - Validate GET CCCs only; drop SET payload-length checks (DW
>   RESPONSE_PORT_DATA_LEN is 0 on SET).
> - Retry GET CCCs only; do not repeat side-effecting SET CCCs.
> - Tighten GETMRL validation to exactly 2 or 3 bytes; add GETMXDS
>   2/5-byte handling.
> - Expand M0 mapping to CRC/parity/transfer-abort, not only frame
>   errors.
> - Restore dests[].payload.len before retry and on error return.
> - Avoid kmalloc on the common single-destination GET path.
> 
> 
> Adrian Ng Ho Yin (5):
>   i3c: ccc: Add actual_len to struct i3c_ccc_cmd_payload
>   i3c: master: Report actual GET CCC payload length on success
>   i3c: master: dw: Map CCC hardware errors to I3C M0/M2
>   i3c: master: Validate GET CCC payload length and retry Direct GET once
>   i3c: master: Add optional_bytes for variable-length GET CCC validation

Tested on RZ/G3E:

Tested-by: Tommaso Merciai <[email protected]>

Kind Regards,
Tommaso

> 
>  drivers/i3c/master.c                   | 97 ++++++++++++++++++++++----
>  drivers/i3c/master/adi-i3c-master.c    |  3 +
>  drivers/i3c/master/dw-i3c-master.c     | 31 ++++++--
>  drivers/i3c/master/i3c-master-cdns.c   |  3 +
>  drivers/i3c/master/mipi-i3c-hci/core.c |  5 +-
>  drivers/i3c/master/renesas-i3c.c       | 16 +++--
>  drivers/i3c/master/svc-i3c-master.c    |  4 +-
>  include/linux/i3c/ccc.h                | 11 ++-
>  8 files changed, 142 insertions(+), 28 deletions(-)
> 
> -- 
> 2.43.7
> 

-- 
linux-i3c mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-i3c