Re: [PATCH] i3c: dw: make struct dw_i3c_cmd smaller

On Thu, Aug 13, 2026 at 04:38:32PM -0400, Frank Li wrote:
> On Thu, Aug 13, 2026 at 12:46:03PM +0800, Jisheng Zhang wrote:
> > The dw_i3c_cmd is dynamically allocated, make it smaller. For example
> > on 64bit platforms, we reduce the size from 48 bytes to 32 bytes.
> >
> > Signed-off-by: Jisheng Zhang <[email protected]>
> > ---
> >  drivers/i3c/master/dw-i3c-master.c | 4 ++--
> >  1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/i3c/master/dw-i3c-master.c b/drivers/i3c/master/dw-i3c-master.c
> > index 6ba84a97765f..d6f84f0f4c2d 100644
> > --- a/drivers/i3c/master/dw-i3c-master.c
> > +++ b/drivers/i3c/master/dw-i3c-master.c
> > @@ -247,10 +247,10 @@ struct dw_i3c_cmd {
> >  	u32 cmd_lo;
> >  	u32 cmd_hi;
> >  	u16 tx_len;
> > -	const void *tx_buf;
> >  	u16 rx_len;
> 
> only switch rx_len and tx_buf should be enough. otherwise there are data
> pad after u8 error.

If we keep the error at the end of the struct, there's still padding
after the u8 error.
There's no big difference between current sol and only switch rx_len and
tx_buf on 32bit platforms. But on 64bit platforms, the current version
makes use of the pad to store the error, thus saves 8 byte more.

Thanks
> 
> Frank
> 
> > -	void *rx_buf;
> >  	u8 error;
> > +	const void *tx_buf;
> > +	void *rx_buf;
> >  };
> >
> >  struct dw_i3c_xfer {
> > --
> > 2.51.0
> >

-- 
linux-i3c mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-i3c