Re: [PATCH v2] i3c: dw: reduce do_daa time if there's no client

Alexandre Belloni <[email protected]>
Newsgroups org.infradead.lists.linux-i3c,org.kernel.vger.linux-kernel
Message-ID <[email protected]>
Hi Jisheng,

On 14/08/2026 12:20:15+0800, Jisheng Zhang wrote:
> dw_i3c_master_daa() derives the number of newly assigned dynamic
> addresses from cmd->rx_len, the ISR sets it to the number of address
> slots ENTDAA left unassigned. It starts out as zero, which already
> means "every address was assigned", so a timed out transfer leaves
> that value in place and it gets used as a result.
> 
> If there's no client connected, the addr assign cmd times out, then
> the driver calls i3c_master_add_i3c_dev_locked() to add devices that
> are not there, each costing about 1s, thus adds non necessary boot
> time up to (maxdev * 1)s.
> 
> Start from maxdevs instead: no address is assigned before ENTDAA runs,
> and make newdevs as 0 if the existing rx_len >= maxdevs.
> 
> Signed-off-by: Jisheng Zhang <[email protected]>
> ---
> 
> since v1:
>  - use another method to remove the non-necessary calling of
>    i3c_master_add_i3c_dev_locked() if there's no client
>  - update commit msg
> 
>  drivers/i3c/master/dw-i3c-master.c | 6 +++++-
>  1 file changed, 5 insertions(+), 1 deletion(-)
> 

You'd have to rebase this one on i3c/next as it doesn't apply cleanly
anymore.

> diff --git a/drivers/i3c/master/dw-i3c-master.c b/drivers/i3c/master/dw-i3c-master.c
> index 1053cfb05c05..883b542c7bfc 100644
> --- a/drivers/i3c/master/dw-i3c-master.c
> +++ b/drivers/i3c/master/dw-i3c-master.c
> @@ -876,6 +876,7 @@ static int dw_i3c_master_daa(struct i3c_master_controller *m)
>  		goto rpm_out;
>  	}
>  	cmd = &xfer->cmds[0];
> +	cmd->rx_len = master->maxdevs;
>  	cmd->cmd_hi = COMMAND_PORT_TRANSFER_ARG;
>  	cmd->cmd_lo = COMMAND_PORT_DEV_COUNT(master->maxdevs - pos) |
>  		      COMMAND_PORT_DEV_INDEX(pos) |
> @@ -888,7 +889,10 @@ static int dw_i3c_master_daa(struct i3c_master_controller *m)
>  	if (!wait_for_completion_timeout(&xfer->comp, XFER_TIMEOUT))
>  		dw_i3c_master_dequeue_xfer(master, xfer);
>  
> -	newdevs = GENMASK(master->maxdevs - cmd->rx_len - 1, 0);
> +	if (cmd->rx_len >= master->maxdevs)
> +		newdevs = 0;
> +	else
> +		newdevs = GENMASK(master->maxdevs - cmd->rx_len - 1, 0);
>  	newdevs &= ~olddevs;
>  
>  	for (pos = 0; pos < master->maxdevs; pos++) {
> -- 
> 2.51.0
> 

-- 
Alexandre Belloni, co-owner and COO, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com

-- 
linux-i3c mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-i3c
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.