Re: [PATCH v5 01/17] spi: dt-bindings: add spi-max-post-config-frequency-hz property
Krzysztof Kozlowski <[email protected]>
| Newsgroups | org.infradead.lists.linux-mtd,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-spi |
|---|---|
| Message-ID | <20260719-camouflaged-unyielding-sawfish-b6fd09@quoll> |
On Sat, Jul 18, 2026 at 12:21:00AM +0530, Santhosh Kumar K wrote: > Add spi-max-post-config-frequency-hz, a generic property for SPI > peripherals that operate at two distinct clock rates: a conservative > rate always reachable without controller configuration, and a higher > rate achievable only after controller-side configuration. > > When both properties are present, spi-max-frequency gives the > conservative pre-configuration rate and spi-max-post-config-frequency-hz > gives the higher post-configuration target. > > Acked-by: Conor Dooley <[email protected]> > Signed-off-by: Santhosh Kumar K <[email protected]> > --- > .../devicetree/bindings/spi/spi-peripheral-props.yaml | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml > index 880a9f624566..12211f8c9f7d 100644 > --- a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml > +++ b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml > @@ -45,6 +45,11 @@ properties: > description: > Maximum SPI clocking speed of the device in Hz. > > + spi-max-post-config-frequency-hz: > + description: > + Maximum SPI clock frequency in Hz achievable after controller-side > + configuration. How did you implement my feedback? Best regards, Krzysztof ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/