RE: [PATCH v3 23/23] mtd: spi-nor: debugfs: Expose SR opcodes and QE mask

Hi Miquel,

> Expose Status Register opcodes based on the flash capabilities
> discovered while parsing the SFDP QER field.
> 
> Value '0' indicates an absence of opcode (non supported), we do not
> print anything in that case.
> 
> The QE bit is also displayed.
> 
> Example on a W25Q02JV-M:
> 
> $ grep opcodes -A10 /sys/kernel/debug/spi-nor/spi0.0/params
> opcodes
>  read           0xec
>   dummy cycles  6
>  erase          0xdc
>  program        0x34
>  SR1 read       0x05
>  SR2 read       0x35
>  SR1+SR2 write  0x01
>  QE             SR2 bit 1
>  8D extension   none
> 
> Signed-off-by: Miquel Raynal <[email protected]>

S25HL512T:
opcodes
 read           0xec
  dummy cycles  10
 erase          0xd8
 program        0x12
 SR1 read       0x05
 SR2 read       0x35
 SR1+SR2 write  0x01
 QE             SR2 bit 1
 8D extension   repeat

S25FS512S:
opcodes
 read           0xec
  dummy cycles  10
 erase          0xdc
 program        0x12
 SR1 read       0x05
 SR2 read       0x35
 SR1+SR2 write  0x01
 QE             SR2 bit 1
 8D extension   none

S25FL256S (no SFDP):
opcodes
 read           0x6c
  dummy cycles  8
 erase          0xdc
 program        0x12
 SR1 read       0x05
 SR2 read       0x35
 SR1+SR2 write  0x01
 QE             SR2 bit 1
 8D extension   none

S28HS512T (Octal, no QE):
opcodes
 read           0xee
  dummy cycles  24
 erase          0xd8
 program        0x12
 SR1 read       0x05
 SR2 read       0x35
 SR1 write      0x01
 SR1+SR2 write  0x01
 8D extension   repeat

Tested-by: Takahiro Kuwano <[email protected]>



______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/