[PATCH v3] nvme: reduce firmware activation poll interval

From: Guzebing <[email protected]>

nvme_fw_act_work() polls the controller processing-paused status every
100 ms while firmware activation is pending. Some devices can complete
online activation in only a few hundred milliseconds, so the fixed
100 ms interval can add up to 100 ms of latency before the driver
observes completion.

nvme_wait_ready() already uses a 1 to 2 ms delay between CSTS reads.
Use the same delay in nvme_fw_act_work() for consistency, and add a
common helper for both paths.

Signed-off-by: Guzebing <[email protected]>
---
Changes in v3:
- Add a common polling delay helper for nvme_fw_act_work() and
  nvme_wait_ready().

Changes in v2:
- Drop the module parameter and use a fixed 1 to 2 ms poll interval.

v2: https://lore.kernel.org/linux-nvme/[email protected]/
v1: https://lore.kernel.org/linux-nvme/[email protected]/

 drivers/nvme/host/core.c | 14 ++++++++++++--
 1 file changed, 12 insertions(+), 2 deletions(-)

diff --git a/drivers/nvme/host/core.c b/drivers/nvme/host/core.c
index 453c1f0b2dd09..499fe36792266 100644
--- a/drivers/nvme/host/core.c
+++ b/drivers/nvme/host/core.c
@@ -2688,6 +2688,16 @@ const struct block_device_operations nvme_bdev_ops = {
 	.pr_ops		= &nvme_pr_ops,
 };
 
+/*
+ * Wait between CSTS reads in nvme_wait_ready() and nvme_fw_act_work().
+ * A 1 to 2 ms interval avoids excessive register reads while allowing
+ * changes in controller status to be detected promptly.
+ */
+static void nvme_busy_wait(void)
+{
+	usleep_range(1000, 2000);
+}
+
 static int nvme_wait_ready(struct nvme_ctrl *ctrl, u32 mask, u32 val,
 		u32 timeout, const char *op)
 {
@@ -2701,7 +2711,7 @@ static int nvme_wait_ready(struct nvme_ctrl *ctrl, u32 mask, u32 val,
 		if ((csts & mask) == val)
 			break;
 
-		usleep_range(1000, 2000);
+		nvme_busy_wait();
 		if (fatal_signal_pending(current))
 			return -EINTR;
 		if (time_after(jiffies, timeout_jiffies)) {
@@ -4813,7 +4823,7 @@ static void nvme_fw_act_work(struct work_struct *work)
 			nvme_try_sched_reset(ctrl);
 			return;
 		}
-		msleep(100);
+		nvme_busy_wait();
 	}
 
 	if (!nvme_change_ctrl_state(ctrl, NVME_CTRL_CONNECTING) ||