Re: [PATCH v9 2/5] phy: qualcomm: hdmi-28lpm: provide dynamic configuration

On Wed, Aug 12, 2026 at 05:28:50PM +0300, Dmitry Baryshkov wrote:
> On Wed, Aug 12, 2026 at 03:51:16PM +0200, Manivannan Sadhasivam wrote:
> > On Wed, May 13, 2026 at 09:14:05PM +0300, Dmitry Baryshkov wrote:
> > > Replace fixed value configuration tables with the values calculated at
> > > the runtime. In some cases the values might differ from the original
> > > values. Those were validated on the IFC6410 board.
> > > 
> > > Signed-off-by: Dmitry Baryshkov <[email protected]>
> > 
> > One nit below. With that fixed,
> > 
> > Acked-by: Manivannan Sadhasivam <[email protected]>
> > 
> > > ---
> > >  drivers/phy/qualcomm/phy-qcom-hdmi-28lpm.c | 325 +++++++++--------------------
> > >  1 file changed, 104 insertions(+), 221 deletions(-)
> > > 
> > > -static const struct pll_rate *qcom_hdmi_8960_pll_find_rate(unsigned long rate)
> > > +static inline void write16(u16 val, void __iomem *reg)
> > 
> > No 'inline' keyword in .c files please.
> 
> Why?
> 

Because the modern compilers are smarter enough to decide whether a specific
function should be inlined or not. There is no guarantee that the 'inline'
keyword that you pass will be honored by the compiler also, it is just a hint.
That's why it is preferred to drop 'inline' keyword from .c files to avoid churn
and leave the judgement to the compilers.

- Mani

-- 
மணிவண்ணன் சதாசிவம்

-- 
linux-phy mailing list
[email protected]
https://lists.infradead.org/mailman/listinfo/linux-phy