Re: [PATCH 02/12] clk: thead: th1520-ap: add support for MISC subsys clocks

Drew Fustini <[email protected]>
Newsgroups org.infradead.lists.linux-phy,org.infradead.lists.linux-riscv,org.kernel.vger.linux-clk,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel,org.kernel.vger.linux-usb
Message-ID <aoOewlbMfey0DLwp@thelio>
On Mon, Aug 17, 2026 at 12:24:26PM +0800, Icenowy Zheng wrote:
> 在 2026-08-16日的 11:12 -0700,Drew Fustini写道:
> > On Tue, Jun 09, 2026 at 09:33:22PM -0700, Drew Fustini wrote:
> > > On Mon, Jun 08, 2026 at 11:15:39PM -0700, Drew Fustini wrote:
> > > > On Tue, Jun 09, 2026 at 02:01:43PM +0800, Icenowy Zheng wrote:
> > > > > 在 2026-06-08一的 23:00 -0700,Drew Fustini写道:
> > > > > > On Thu, May 07, 2026 at 04:17:00PM +0800, Icenowy Zheng
> > > > > > wrote:
> > > > > > > The TH1520 SoC contains a MISC_SUBSYS clock controller,
> > > > > > > which
> > > > > > > allows
> > > > > > > controlling of USB related clocks and MMC/SD controller AHB
> > > > > > > bus
> > > > > > > clocks.
> > > > > > > 
> > > > > > > Add support for this clock controller, in order to enable
> > > > > > > USB
> > > > > > > support.
> > > > > > > 
> > > > > > > Signed-off-by: Icenowy Zheng <[email protected]>
> > > > > > > ---
> > > > > > >  drivers/clk/thead/clk-th1520-ap.c | 64
> > > > > > > +++++++++++++++++++++++++++++++
> > > > > > >  1 file changed, 64 insertions(+)
> > > > > > > 
> > > > > > > diff --git a/drivers/clk/thead/clk-th1520-ap.c
> > > > > > > b/drivers/clk/thead/clk-th1520-ap.c
> > > > > > > index 3a6847f1c950f..24f785f0b329a 100644
> > > > > > > --- a/drivers/clk/thead/clk-th1520-ap.c
> > > > > > > +++ b/drivers/clk/thead/clk-th1520-ap.c
> > > > > > [...]
> > > > > > > @@ -1609,6 +1663,12 @@ static int th1520_clk_probe(struct
> > > > > > > platform_device *pdev)
> > > > > > >  			return ret;
> > > > > > >  	}
> > > > > > >  
> > > > > > > +	if (plat_data == &th1520_ap_platdata) {
> > > > > > > +		ret = devm_clk_hw_register(dev,
> > > > > > > &usb_suspend_div_clk.hw);
> > > > > > > +		if (ret)
> > > > > > > +			return ret;
> > > > > > > +	}
> > > > > > 
> > > > > > Should usb_suspend_div_clk.hw instead be registered under
> > > > > > 'if (plat_data == &th1520_ap_platdata)'?
> > > > > 
> > > > > Do you mean misc_platdata?
> > > > > 
> > > > > Yes, this is an copy-n-paste error that deserves a fix.
> > > > 
> > > > Hah, yes, I also had a typo :)
> > > 
> > > Assuming that gets fixed in the next rev:
> > > 
> > > Reviewed-by: Drew Fusini <[email protected]>
> > 
> > I will fixup the typo and apply to thead-clk-for-next once 7.3-rc1 is
> > released.
> 
> BTW I think the binding patch should go through your tree too.

Yes, I will plan to take patch 1 and 2 through thead-clk-for-next and
patch 3 through thead-dt-for-next.

Thanks,
Drew

-- 
linux-phy mailing list
[email protected]
https://lists.infradead.org/mailman/listinfo/linux-phy
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.