Re: [PATCH 10/10] ARM: dts: qcom: apq8074-dragonboard: enable the HSIC host
Konrad Dybcio <[email protected]>
| Newsgroups | org.infradead.lists.linux-phy,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel,org.kernel.vger.linux-usb |
|---|---|
| Message-ID | <[email protected]> |
On 8/10/26 5:42 PM, Dmitry Baryshkov wrote: > The dragonboard carries an SMSC USB4604 HSIC hub, but with the HSIC > controller undescribed the whole HSIC-attached part of the board is > dead. > > Enable the HSIC controller. The USB4604 hub isn't controllable through > the I2C because of the board design issues, so reference it as a simple > USB device, describing the reset line. > > Assisted-by: Claude:claude-fable-5 > Signed-off-by: Dmitry Baryshkov <[email protected]> > --- Reviewed-by: Konrad Dybcio <[email protected]> Konrad -- linux-phy mailing list [email protected] https://lists.infradead.org/mailman/listinfo/linux-phy