Re: [RFC PATCH] arm64: dts: rockchip: H28K: release RTL8211F reset before MDIO probing

> This is an RFC: snps,reset-gpios is deprecated in favour of the
> ethernet-PHY reset bindings, so feedback on the preferred way to release
> the reset early is welcome.

> + snps,reset-gpios = <&gpio4 RK_PC2 GPIO_ACTIVE_LOW>;
> + snps,reset-delays-us = <0 20000 100000>;

  snps,reset-gpio:
    deprecated: true
    maxItems: 1
    description:
      PHY Reset GPIO

  snps,reset-active-low:
    deprecated: true
    $ref: /schemas/types.yaml#/definitions/flag
    description:
      Indicates that the PHY Reset is active low

  snps,reset-delays-us:
    deprecated: true
    description:
      Triplet of delays. The 1st cell is reset pre-delay in micro
      seconds. The 2nd cell is reset pulse in micro seconds. The 3rd
      cell is reset post-delay in micro seconds.
    minItems: 3
    maxItems: 3

As you say, deprecated: true. You should not be adding new uses of
deprecated properties.

Try using the reset properties in mdio.yaml

    Andrew

_______________________________________________
Linux-rockchip mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-rockchip