[PATCH 1/2] pinctrl: rockchip: Reset the pin count when recalculating SoC data

Simon Glass <[email protected]> Mon, 3 Aug 2026 08:10:23 -0600
Newsgroups org.infradead.lists.linux-rockchip,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel
Message-ID <20260803081024.1.72f72067ea890a9eac79d63bf655738bec374dfd@changeid>
rockchip_pinctrl_get_soc_data() mutates the static per-SoC data. The
iomux and drive offsets are recalculated idempotently, since a rerun
anchors at the values calculated before, but the total pin count only
accumulates: each run adds every bank's pins again. When the probe is
deferred and runs a second time, nr_pins doubles and every bank's
pin_base shifts, so later pin lookups resolve to the wrong bank and
the wrong registers.

Reset the pin count at the start of the calculation, so that a rerun
produces the same values.

This is verified on a Luckfox Pico Mini B (RV1103, with the pending
RV1106 series applied) by forcing the probe to defer once: without
this patch the second probe calculates nr_pins=304 instead of 152 and
no GPIO bank comes up; with it the recalculation matches the first
run and all banks work.

Fixes: d3e5116119bd ("pinctrl: add pinctrl driver for Rockchip SoCs")
Link: https://sashiko.dev/#/patchset/[email protected]?part=4
Assisted-by: Claude:claude-opus-5
Signed-off-by: Simon Glass <[email protected]>

---

 drivers/pinctrl/pinctrl-rockchip.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c
index 7e0fcd45fd26..8bfc7ab5de15 100644
--- a/drivers/pinctrl/pinctrl-rockchip.c
+++ b/drivers/pinctrl/pinctrl-rockchip.c
@@ -4296,6 +4296,16 @@ static struct rockchip_pin_ctrl *rockchip_pinctrl_get_soc_data(
 	pmu_offs = ctrl->pmu_mux_offset;
 	drv_pmu_offs = ctrl->pmu_drv_offset;
 	drv_grf_offs = ctrl->grf_drv_offset;
+
+	/*
+	 * This function mutates the static per-SoC data. Most of it is
+	 * idempotent: recalculated iomux and drv offsets anchor at the
+	 * values calculated by a previous run. The pin count is not, so
+	 * reset it here; otherwise it accumulates when the probe runs
+	 * again after a probe deferral, shifting every bank's pin_base.
+	 */
+	ctrl->nr_pins = 0;
+
 	bank = ctrl->pin_banks;
 	for (i = 0; i < ctrl->nr_banks; ++i, ++bank) {
 		int bank_pins = 0;
-- 
2.43.0


_______________________________________________
Linux-rockchip mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-rockchip