[PATCH v14 02/38] phy: rockchip: usbdp: Update mode_change after error handling

If rk_udphy_init() or rk_udphy_setup() fails, the reinit will not be
tried again. Fix this by only updating the variable after all potential
errors have been handled.

Note, that no errors have been seen on real hardware and failures would
most likely be fatal and require at least a full reboot as the function
already asserts the PHY reset lines. So this is more of a theoretical
issue.

Fixes: 2f70bbddeb45 ("phy: rockchip: add usbdp combo phy driver")
Reported-by: Sashiko <[email protected]>
Closes: https://lore.kernel.org/linux-phy/[email protected]/
Tested-by: Igor Paunovic <[email protected]> # Orange Pi 5 Plus
Signed-off-by: Sebastian Reichel <[email protected]>
---
 drivers/phy/rockchip/phy-rockchip-usbdp.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-usbdp.c b/drivers/phy/rockchip/phy-rockchip-usbdp.c
index fba35510d88c..a5ffdf7a6e76 100644
--- a/drivers/phy/rockchip/phy-rockchip-usbdp.c
+++ b/drivers/phy/rockchip/phy-rockchip-usbdp.c
@@ -1000,15 +1000,14 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
 	}
 
 	if (udphy->status == UDPHY_MODE_NONE) {
-		udphy->mode_change = false;
 		ret = rk_udphy_setup(udphy);
 		if (ret)
 			return ret;
 
 		if (udphy->mode & UDPHY_MODE_USB)
 			rk_udphy_u3_port_disable(udphy, false);
-	} else if (udphy->mode_change) {
 		udphy->mode_change = false;
+	} else if (udphy->mode_change) {
 		udphy->status = UDPHY_MODE_NONE;
 		if (udphy->mode == UDPHY_MODE_DP)
 			rk_udphy_u3_port_disable(udphy, true);
@@ -1017,6 +1016,7 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
 		ret = rk_udphy_setup(udphy);
 		if (ret)
 			return ret;
+		udphy->mode_change = false;
 	}
 
 	udphy->status |= mode;

-- 
2.53.0


_______________________________________________
Linux-rockchip mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-rockchip