Re: [PATCH v7 1/5] dt-bindings: display: bridge: analogix-dp: Add data-lanes support for endpoint
Luca Ceresoli <[email protected]>
| Newsgroups | org.infradead.lists.linux-rockchip,org.freedesktop.lists.dri-devel,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <178714408665.358642.12561443857141730089.b4-review@b4> |
On Wed, 19 Aug 2026 15:52:34 +0800, Damon Ding <[email protected]> wrote: > Add data-lanes property support to the port@1 endpoint for physical > lane mapping configuration. > > Lane mapping is mainly used for below scenarios: > 1. Correct PCB lane swap and differential line routing crossover > without hardware changes; > 2. Adapt mismatched lane pin definitions between SoC and eDP panel; > 3. Support multiple panel hardware variants on the same board > by configuring data-lanes in device tree only. > > [...] Reviewed-by: Luca Ceresoli <[email protected]> -- Luca Ceresoli, Bootlin Embedded Linux and Kernel engineering https://bootlin.com _______________________________________________ Linux-rockchip mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-rockchip