Re: [RFC PATCH] firmware: scmi: Make SCMI arch independent

On 7/9/26 17:56, Cristian Marussi wrote:
> On Thu, Jul 09, 2026 at 03:27:00PM +0200, Michal Simek wrote:
>> On heterogenious systems like AMD/Xilinx FPGA there is a need to talk to
>> SCMI server from different architectures than ARM that's why remove
>> ARM/ARM64 Kconfig dependency with also remove ARM from description and
>> rename folder to reflect it.
> 
> While I understand dropping the dependency on ARM (I always wanted to do
> that and test if it worked at all on some otehr archs with QEMU), I am
> not sure about the whole renaming party ? why is needed just for
> cosmetic reasons ? it is at the end an arm originated protocol so I dont
> see it as a being wrong to be named as such even though used by other
> archs...I have not really strong opinion on this...

I have been in CC on U-Boot RPMI patches which got to my attention because
I don't want to have another interface for MB-V(riscv-) running in programmable 
logic and have another server in the system doing the same thing.

Based on that we had discussed about it with Vincent and Souvik (we missed you 
there) about using SCMI on non ARM platform and both of them didn't see the 
concern to be marked as ARM only protocol.
Truth is that some of protocols have ARM in description, file names, etc but 
some of them not. That's why I think it is good time to sync it up and enable
running this protocol on other SOCs.

> ... my concern really is ... wont this full scale rename simply generate
> a lot of un-needed churn for future fixes and/or backporting ?
I don't think it is going to be a big problem because it is just git mv which 
git is able to gracefully handle.

Thanks,
Michal