Re: [PATCH 01/10] Documentation: filesystems: autofs-mount-control: drop doubled words

On Fri, 2020-07-03 at 14:43 -0700, Randy Dunlap wrote:
> Drop the doubled words "the" and "and".
> 
> Signed-off-by: Randy Dunlap <[email protected]>
> Cc: Jonathan Corbet <[email protected]>
> Cc: [email protected]
> Cc: Ian Kent <[email protected]>

Acked-by: Ian Kent <[email protected]>

> Cc: [email protected]
> ---
>  Documentation/filesystems/autofs-mount-control.rst |    6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> --- linux-next-20200701.orig/Documentation/filesystems/autofs-mount-
> control.rst
> +++ linux-next-20200701/Documentation/filesystems/autofs-mount-
> control.rst
> @@ -391,7 +391,7 @@ variation uses the path and optionally i
>  set to an autofs mount type. The call returns 1 if this is a mount
> point
>  and sets out.devid field to the device number of the mount and
> out.magic
>  field to the relevant super block magic number (described below) or
> 0 if
> -it isn't a mountpoint. In both cases the the device number (as
> returned
> +it isn't a mountpoint. In both cases the device number (as returned
>  by new_encode_dev()) is returned in out.devid field.
>  
>  If supplied with a file descriptor we're looking for a specific
> mount,
> @@ -399,12 +399,12 @@ not necessarily at the top of the mounte
>  the descriptor corresponds to is considered a mountpoint if it is
> itself
>  a mountpoint or contains a mount, such as a multi-mount without a
> root
>  mount. In this case we return 1 if the descriptor corresponds to a
> mount
> -point and and also returns the super magic of the covering mount if
> there
> +point and also returns the super magic of the covering mount if
> there
>  is one or 0 if it isn't a mountpoint.
>  
>  If a path is supplied (and the ioctlfd field is set to -1) then the
> path
>  is looked up and is checked to see if it is the root of a mount. If
> a
>  type is also given we are looking for a particular autofs mount and
> if
> -a match isn't found a fail is returned. If the the located path is
> the
> +a match isn't found a fail is returned. If the located path is the
>  root of a mount 1 is returned along with the super magic of the
> mount
>  or 0 otherwise.