[PATCH] backports: Update hwsim defconfig

In the current hwsim config no rate control algorithm is enabled. This
means that, when using defconfig-hwsim, the mac80211_hwsim fails to load
with the following error:

	[  132.155183] ieee80211 phy0: Failed to select rate control algorithm
	[  132.155196] ieee80211 phy0: Failed to initialize rate control algorithm

Fix this by enabling rate control algorithms in the provided hwsim
config.

Experiments were also less reliable when WEXT was enabled. So this patch
also disables WEXT when using defconfig-hwsim to make the default more
reliable for users.

Signed-off-by: Mathy Vanhoef <[email protected]>
---
 backport/defconfigs/hwsim | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/backport/defconfigs/hwsim b/backport/defconfigs/hwsim
index 9d8006ea..9f054c79 100644
--- a/backport/defconfigs/hwsim
+++ b/backport/defconfigs/hwsim
@@ -1,11 +1,15 @@
 CPTCFG_CFG80211=m
 CPTCFG_CFG80211_DEFAULT_PS=y
 CPTCFG_CFG80211_DEBUGFS=y
-CPTCFG_CFG80211_WEXT=y
+CPTCFG_CFG80211_WEXT=n
 CPTCFG_MAC80211=m
+
 # CPTCFG_MAC80211_RC_PID is not set
-# CPTCFG_MAC80211_RC_MINSTREL is not set
-# CPTCFG_MAC80211_RC_DEFAULT_MINSTREL is not set
+CPTCFG_MAC80211_HAS_RC=y
+CPTCFG_MAC80211_RC_MINSTREL=y
+CPTCFG_MAC80211_RC_DEFAULT_MINSTREL=y
+CPTCFG_MAC80211_RC_DEFAULT="minstrel_ht"
+
 CPTCFG_MAC80211_DEBUGFS=y
 CPTCFG_MAC80211_MESSAGE_TRACING=y
 CPTCFG_WLAN=y
-- 
2.35.1

--
To unsubscribe from this list: send the line "unsubscribe backports" in