Re: Delays, clocks, timers, hrtimers, etc

Stephen Boyd wrote:

> Mason wrote:
>
>> My platform provides a 32-bit counter, ticking at a constant 27 MHz.
>> Reading this counter has a latency of roughly 70 ns (it has to go
>> over the system memory bus). I think this is good enough for both
>> the clock source and sched_clock, is it not?
>>
>> So the plan would be:
>> - clocksource and sched_clock : 27 MHz, 32-bit counter, platform
>> - clockevents : TWD, standard
>
> Yep, that sounds like a good plan. If your platform has the ARM global
> timer (drivers/clocksource/arm_global_timer.c) then you don't need
> anything besides that timer because it provides both the clocksource,
> sched_clock, and clockevents. Sounds like you don't have that timer

I'm using Cortex A9, so I do have the global timer (AFAIU).

However, I don't think I can safely use it as a clock source because
I'm also using cpufreq, and I don't think the arm_global_timer driver
handles CPU frequency updates, while the TWD driver does (?)

/*
  * Updates clockevent frequency when the cpu frequency changes.
  * Called on the cpu that is changing frequency with interrupts disabled.
  */

"The Interrupt Controller, global timer, private timers, and watchdogs
are clocked with PERIPHCLK." And PERIPHCLK is tied to CLK, which is
modified by cpufreq. I didn't see any code in the arm_global_timer
driver to deal with with that.

Did I overlook something fundamental?

> though, so you have to write a driver for your custom platform timer and
> at least hook up clocksource and sched_clock to it. If you have
> interrupts with your platform timer you can skip out on TWD and also
> register a clockevent in your platform timer driver.

Registering a clock source or a sched_clock seems straight-forward.
All I need to provide is a function to read the platform counter.

However, why would I skip out on TWD?
(I'm trying to minimize code needed for the port.)

Regards.