Re: [PATCH v3] schemas: pci: Document PCIe T_POWER_ON
Manivannan Sadhasivam <[email protected]> Wed, 26 Nov 2025 19:00:00 +0530
| Newsgroups | org.kernel.vger.devicetree-spec,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pci |
|---|---|
| Message-ID | <ek7xcuknyoadyel7btqqhdeqlw77yjt6itzzsujxud36rj4hjw@yzxj6lce2qy4> |
On Wed, Nov 26, 2025 at 04:01:12PM +0530, Krishna Chaitanya Chundru wrote: > From PCIe r7, sec 5.5.4 & Table 5-11 in sec 5.5.5 T_POWER_ON is the > minimum amount of time(in us) that each component must wait in L1.2.Exit > after sampling CLKREQ# asserted before actively driving the interface to > ensure no device is ever actively driving into an unpowered component and > these values are based on the components and AC coupling capacitors used > in the connection linking the two components. > > This property should be used to indicate the T_POWER_ON and drivers using > this property are responsible for parsing both the scale and the value of s/parsing/programming > T_POWER_ON to comply with the PCIe specification. > > Signed-off-by: Krishna Chaitanya Chundru <[email protected]> Acked-by: Manivannan Sadhasivam <[email protected]> - Mani > --- > Changes in v2: > - Move the property to pci-device.yaml so that it will be applicable to > endpoint devices also (Mani). > - Use latest spec (Lukas) > - Link to v2: https://lore.kernel.org/all/[email protected]/ > Changes in v1: > - Updated the commiit text (Mani). > - Link to v1: https://lore.kernel.org/all/[email protected]/#t > > dtschema/schemas/pci/pci-device.yaml | 9 +++++++++ > 1 file changed, 9 insertions(+) > > diff --git a/dtschema/schemas/pci/pci-device.yaml b/dtschema/schemas/pci/pci-device.yaml > index ca094a0..4baab71 100644 > --- a/dtschema/schemas/pci/pci-device.yaml > +++ b/dtschema/schemas/pci/pci-device.yaml > @@ -63,6 +63,15 @@ properties: > description: GPIO controlled connection to WAKE# signal > maxItems: 1 > > + t-power-on-us: > + description: > + The minimum amount of time that each component must wait in > + L1.2.Exit after sampling CLKREQ# asserted before actively driving > + the interface to ensure no device is ever actively driving into an > + unpowered component. This value is based on the components and AC > + coupling capacitors used in the connection linking the two > + components(PCIe r7.0, sec 5.5.4). > + > required: > - reg > > -- > 2.34.1 > -- மணிவண்ணன் சதாசிவம்