Re: [PATCH v3 02/52] powerpc/64s: guard optional TIDR SPR with CPU ftr test

Michael Ellerman <[email protected]> writes:

> Fabiano Rosas <[email protected]> writes:
>> Nicholas Piggin <[email protected]> writes:
>>
>>> The TIDR SPR only exists on POWER9. Avoid accessing it when the
>>> feature bit for it is not set.
>>
>> Not related to this patch, but how does this work with compat mode? A P9
>> compat mode guest would get an invalid instruction when trying to access
>> this SPR?
>
> Good question.
>
> I assume you're talking about P9 compat mode on P10.
>
> In general compat mode only applies to userspace, because it's
> implemented by setting the PCR which only (mostly?) applies to PR=1.
>
> I don't think there's any special casing in the ISA for the TIDR, so I
> think it just falls into the unimplemented SPR case for mt/fspr.
>
> That's documented in Book III section 5.4.4, in particular on page 1171
> it says:
>
>   Execution of this instruction specifying an SPR number
>   that is undefined for the implementation causes one of
>   the following.
>   • if spr[0]=0:
>     - if MSR[PR]=1: Hypervisor Emulation Assistance interrupt
>     - if MSR[PR]=0: Hypervisor Emulation Assistance interrupt for SPR
>       0,4,5, and 6, and no operation (i.e., the instruction is treated
>       as a no-op) when LPCR[EVIRT]=0 and Hypervisor Emulation Assistance
>       interrupt when LPCR[EVIRT]=1 for all other SPRs

I knew this must have been somewhere in there but had no idea how to
find it. Thanks.

> Linux doesn't set EVIRT, and I assume neither does phyp, so it behaves
> like a nop.
>
> We actually use that behaviour in xmon to detect that an SPR is not
> implemented, by noticing that the mfspr has no effect on the target
> register, see dump_one_spr().
>
> We should really write some docs on compat mode in the linuxppc wiki
> and/or Documentation ;)

Hmm I was not aware we had a wiki. I'll see if I can contribute
something. I need to go learn all this stuff first, though =D.

>
> cheers