Re: [PATCH 1/4] KVM: x86/mmu: Reload MMU on *every* page pre-fault attempt/iteration

Sean Christopherson <[email protected]>
Newsgroups org.kernel.vger.kvm,org.kernel.vger.linux-kernel
Message-ID <[email protected]>
On Fri, Aug 07, 2026, Rick P Edgecombe wrote:
> On Thu, 2026-08-06 at 14:40 -0700, Sean Christopherson wrote:
> > Reload the MMU (which is a nop if the MMU doesn't need to be reloaded) on
> > every attempt to pre-fault a guest page, i.e. when the page fault path
> > signals that the caller should retry.  If the synchronize_srcu_expedited()
> > in kvm_invalidate_memslot() completes before kvm_vcpu_pre_fault_memory()
> > grabs SRCU, but kvm_mmu_reload() in the pre-fault path completes before
> > kvm_invalidate_memslot() triggers x86's "fast zap all", then the pre-fault
> > task will reach kvm_tdp_page_prefault() with an invalid root.
> > 
> > Attempting to fault-in memory with an invalid root ultimately puts
> > kvm_tdp_page_prefault() into an infinite (breakable) retry loop, which
> > manifests most obviously as a hang in the pre_fault_memory_test selftest,
> > but also eventually causes RCU (SRCU?) to complain.
> > 
> >   INFO: rcu_tasks detected stalls on tasks:
> >   000000000cda47bd: .. nvcsw: 6/6 holdout: 1 idle_cpu: -1/25
> >   task:pre_fault_memor state:R  running task     stack:12696
> >   pid:95588 tgid:95588 ppid:95584  task_flags:0x400000 flags:0x00080801
> >   Call Trace:
> >    <TASK>
> >    lock_release+0x4e/0x320
> >    __get_user_pages+0x546/0xcd0
> >    up_read+0x1b/0x30
> >    get_user_pages_unlocked+0xee/0x350
> >    hva_to_pfn+0xd3/0x3d0 [kvm]
> >    lock_release+0x4e/0x320
> >    xa_load+0x5c/0x170
> >    xa_load+0x14c/0x170
> >    __kvm_faultin_pfn+0xd9/0x130 [kvm]
> >    lock_acquire+0x65/0x2b0
> >    lock_release+0x4e/0x320
> >    kvm_mmu_faultin_pfn+0x1e1/0x690 [kvm]
> >    gup_fast_fallback+0x63e/0xdf0
> >    kvm_tdp_page_fault+0xeb/0x140 [kvm]
> >    kvm_mmu_do_page_fault+0x12e/0x200 [kvm]
> >    kvm_arch_vcpu_pre_fault_memory+0x16e/0x200 [kvm]
> >    kvm_vcpu_pre_fault_memory+0xc1/0x1f0 [kvm]
> >    kvm_vcpu_pre_fault_memory+0x116/0x1f0 [kvm]
> >    kvm_vcpu_ioctl+0x3a4/0x6b0 [kvm]
> >    clockevents_program_event+0x5d/0x170
> >    __se_sys_ioctl+0x6d/0xb0
> >    entry_SYSCALL_64_after_hwframe+0x4b/0x53
> >    do_syscall_64+0x10a/0x480
> >    __irq_exit_rcu+0x8e/0x140
> >    entry_SYSCALL_64_after_hwframe+0x4b/0x53
> >    </TASK>
> > 
> > Fixes: 6e01b7601dfe ("KVM: x86: Implement kvm_arch_vcpu_pre_fault_memory()")
> > Signed-off-by: Sean Christopherson <[email protected]>
> 
> 
> Reviewed-by: Rick Edgecombe <[email protected]>
> 
> But, did you hit this somehow with an unmodified test and kernel? The log makes
> me think it was hit in a normal test run. (which I failed to reproduce)

Yes and yes.  I often test by running all selftests in parallel.  My guess is that
PREEMPT_LAZY plus oversubscribed CPUs allowed the timing condition to be hit.  It
wasn't anywhere near 100% reproducible on my end either, maybe 1 out of every 10
runs?  20 runs?  (of the entire suite of selftests).

P.S. I was very proud of myself: because the failure was so flaky, I used perf
and bpftrace to debug the issue instead of my usual hack-the-kernel approach. :-)
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.